Power Supply Units
Section 3-4
Use round crimp terminals for wiring. Do not connect bare stranded wires direct
-
ly to terminal blocks. Use M3.5 screws for tightening crimp terminals.
7
mm max.
Caution Tighten the screws on the terminal block of the AC Power Supply Unit to a torque
!
of 0.8 N
tion.
S
m. The loose screws may result in short-circuit, burning, or malfunc-
20 mm max.
M3.5 screw
Tightening torque: 0.8 N S m
WARNING Always attach crimp terminals to the wires to ensure proper connection.
!
Connecting loose wires can cause fires.
Caution Abide by the following precautions when wiring the Power Supply Units. Failure
!
to abide by these precautions my cause faulty operation or damage to the Unit.
• Be sure that no wire clippings or other foreign materials enter the Units when
wiring.
• Check and recheck all wiring before supplying power to the system.
Note The RUN output on Slave Racks will go OFF when a remote I/O error occurs.
56
OMRON [ OMRON ELECTRONICS LLC ]
