欢迎访问ic37.com |
会员登录 免费注册
发布采购

ML2502 参数 Datasheet PDF下载

ML2502图片预览
型号: ML2502
PDF下载: 下载PDF文件 查看货源
内容描述: 128Kbit的模拟电池容量闪存修订版8.0 1999年4月1日 [128Kbit Analog Cell Storage Flash Memory Revision 8.0 Apr. 01, 1999]
分类和应用: 闪存电池
文件页数/大小: 20 页 / 119 K
品牌: OKI [ OKI ELECTRONIC COMPONETS ]
 浏览型号ML2502的Datasheet PDF文件第1页浏览型号ML2502的Datasheet PDF文件第2页浏览型号ML2502的Datasheet PDF文件第3页浏览型号ML2502的Datasheet PDF文件第5页浏览型号ML2502的Datasheet PDF文件第6页浏览型号ML2502的Datasheet PDF文件第7页浏览型号ML2502的Datasheet PDF文件第8页浏览型号ML2502的Datasheet PDF文件第9页  
OKI  
ML2502  
n Record/Playback Operation  
ML2502 has two record/playback modes, Dual-phrase record/playback mode and Single-  
phrase record/playback mode. While in Dual-phrase record/playback mode the total memory  
space is divided evenly into two areas for 2-phrase record/playback, the entire memory space  
is used for one phrase record/playback in Single-phrase record/playback mode.  
In Dual-phrase record/playback mode the first half of the memory, i.e. from the top address up  
to the center address, is assigned to Phrase 1, and the second half, i.e. from the center  
address to the last address, is assigned to Phrase 2. Record/playback of Phrase 1 can be  
controlled via the REC1 and PLAY1 pins, while Phrase 2 can be controlled via the REC2 and  
PLAY2 pins respectively.  
In Single-phrase mode record/playback must be performed with the REC1 being connected to  
the REC2 pin and the PLAY1 being connected to the PLAY2 pin respectively.  
In both playback modes repetitive playback function for the same phrase is available.  
1. Dual-Phrase Record/Playback Mode  
1.1 Phrase 1 Recording Operation  
(1)  
Keep on inputting “H” level to the REC1 pin to power up and start recording from the top  
address of the memory. Recording goes on while the REC1 pin being held “H” level.  
The LSI automatically ends recording when the center address has been reached.  
The LSI automatically shifts to low-power consumption mode after recording ends.  
To stop recording for phrase 1 before reaching the center address, bring the REC1 pin  
down to “L” level. The LSI automatically shifts to low-power consumption mode after  
recording stops.  
(2)  
(3)  
(4)  
(5)  
During recording operation any signal input to other pins than the REC1 is disregarded.  
Note: Re-recording always causes to overwrite the existing recording data for a given  
phrase.  
Start  
Invalid Input  
Stop  
REC1  
REC2  
MON  
Power Down  
Powering Up  
Recording  
Powering Down  
Power Down  
Status  
Stopping Process  
Figure 1.1 Timing Chart for Phrase 1 Recording Operation  
ML2502 Data Sheet (Revision 8.0)  
4