Military Version
AC Electrical Characteristics
=
=
=
VEE −4.2V to −5.7V, VCC VCCA GND
=
=
=
Symbol
Parameter
TC −55˚C
TC +25˚C
TC +125˚C Units
Conditions
Notes
Min
Max
Min
Max
Min
Max
tPLH
tPHL
Propagation Delay
Dna–Dnd to Output
(Transparent Mode)
Propagation Delay
S0, S1 to Output
(Transparent Mode)
Propagation Delay
E1, E2 to Output
Propagation Delay
MR to Output
0.40
2.30
0.50
2.20
0.50
2.60
ns
tPLH
tPHL
Figures 1, 2
0.60
0.50
0.60
0.40
3.00
2.60
2.80
1.90
0.80
0.60
0.70
0.40
2.70
2.30
2.60
1.90
0.80
0.70
0.70
0.40
3.20
2.70
2.90
1.90
ns
ns
ns
ns
(Notes 8, 9,
10)
tPLH
tPHL
tPLH
tPHL
tTLH
tTHL
tS
Figures 1, 3
Figures 1, 2
(Notes 8, 9,
10)
Transition Time
(Note 11)
20% to 80%, 80% to 20%
Setup Time
D
na–Dnd
0.90
2.40
1.50
0.90
2.40
1.50
0.90
2.40
1.50
ns
Figure 4
Figure 3
Figure 4
(Note 11)
S0, S1
MR (Release Time)
Hold Time
tH
Dna–Dnd
0.40
0.00
2.00
2.00
0.40
0.00
2.00
2.00
0.40
0.00
2.00
2.00
ns
(Note 11)
S0, S1
tpw (L)
tpw (H)
Pulse Width LOW E1, E2
Pulse Width HIGH MR
ns
ns
Figure 2
Figure 3
(Note 11)
(Note 11)
Note 8: F100K 300 Series cold temperature testing is performed by temperature soaking (to guarantee junction temperature equals −55˚C), then testing immediately
without allowing for the junction temperature to stabilize due to heat dissipation after power-up. This provides “cold start” specs which can be considered a worst case
condition at cold temperatures.
Note 9: Screen tested 100% on each device at +25˚C, Temperature only, Subgroup A9.
Note 10: Sample tested (Method 5005, Table 1) on each Mfg. lot at +25˚, Subgroup A9, and at +125˚C, and −55˚C Temp., Subgroups A10 & A11.
Note 11: Not tested at +25˚C, +125˚C and −55˚C Temperature (design characterization data).
5
www.national.com
NSC [ National Semiconductor ]
