Spec No. J(E)TE243A-0004
Reference Only
5/9
DFE252010C Type
一般仕様
General Specifications ( 3/3 )
標準状態
Standard atmospheric conditions
特に指定が無い限り、測定は常温(温度 5�½�35℃)、常湿(湿度45�½�85%)、常気圧(気圧86�½�106kPa)にて行う。
ただし、判定に疑義を生じた場合は温度20±2℃、湿度65±5%、気圧86�½�106kPaにて行う。
Unless otherwise specified, the standard range of atmospheric conditions in making measurements and test as follows;
Ambient temperature : 5℃ to 35℃ , Relative humidity : 45% to 85% ,
Air pressure : 86kPa to 106kPa
If more strict measurement is required, measurement shall be made within following limits;
Ambient temperature : 20±2℃ ,
Relative humidity : 65±5% ,
Air pressure : 86kPa to 106kPa
リフロ�½�はんだ条件
Reflow soldering condition
*リフロ�½�回数
:
2回まで
Reflow times
:
2 times max
*リフロ�½�炉の熱源には、遠赤外線を推奨致します。
熱源としてハロ�½�゙ン��ンプを�½�用されますと、輻射熱が
高く、耐熱範囲を超える場合があり推奨できません。
We recommend infrared ray as heat source of reflow bath.
However halogen lamp shall be used, side heat will be beyond
range of resistance heat, so we can’t recommend it.
推奨パタ�½�ン図
Recommended PCB pattern
単�½�
Unit : mm