DATA SHEET
MSP 34x0G
Table 3–11: Write Registers on I2C Subaddress 12hex, continued
Register
Address
Function
Name
SCART SWITCHES AND DIGITAL I/O PINS
00 13hex
ACB Register
ACB_REG
Defines the level of the digital output pins and the position of the SCART
switches
bit[15]
0/1
low/high of digital output pin D_CTR_I/O_1
(MODUS[3]=0)
bit[14]
0/1
low/high of digital output pin D_CTR_I/O_0
(MODUS[3]=0)
bit[13:5] SCART DSP Input Select
xxxx00xx0 SCART1 to DSP input (RESET position)
xxxx01xx0 MONO to DSP input (set Sound A Mono in the channel
matrix mode for the corresponding output channels)
xxxx10xx0 SCART2 to DSP input
xxxx11xx0 SCART3 to DSP input
xxxx00xx1 SCART4 to DSP input
xxxx11xx1 mute DSP input
bit[13:5] SCART1 Output Select
xx00xxx0x SCART3 input to SCART1 output (RESET position)
xx01xxx0x SCART2 input to SCART1 output
xx10xxx0x MONO input to SCART1 output
xx11xxx0x SCART1 DA to SCART1 output
xx00xxx1x SCART2 DA to SCART1 output
xx01xxx1x SCART1 input to SCART1 output
xx10xxx1x SCART4 input to SCART1 output
xx11xxx1x mute SCART1 output
bit[13:5] SCART2 Output Select
00xxxx0xx SCART1 DA to SCART2 output (RESET position)
01xxxx0xx SCART1 input to SCART2 output
10xxxx0xx MONO input to SCART2 output
00xxxx1xx SCART2 DA to SCART2 output
01xxxx1xx SCART2 input to SCART2 output
10xxxx1xx SCART3 input to SCART2 output
11xxxx1xx SCART4 input to SCART2 output
11xxxx0xx mute SCART2 output
bit[4:0]
must be zero
The RESET position becomes active at the time of the first write transmission
on the control bus to the audio processing part. By writing to the ACB register
first, the RESET state can be redefined.
BEEPER
00 14hex
Beeper Volume and Frequency
BEEPER
bit[15:8] Beeper Volume
00hex
7Fhex
off
maximum volume
bit[7:0]
Beeper Frequency
01hex
40hex
FFhex
16 Hz (lowest)
1 kHz
4 kHz
Micronas
May 27, 2003; 6251-476-1DS
41
MICRONAS [ MICRONAS ]
