欢迎访问ic37.com |
会员登录 免费注册
发布采购

TCN75AVUA 参数 Datasheet PDF下载

TCN75AVUA图片预览
型号: TCN75AVUA
PDF下载: 下载PDF文件 查看货源
内容描述: 2线串行温度传感器 [2-Wire Serial Temperature Sensor]
分类和应用: 传感器温度传感器
文件页数/大小: 32 页 / 1046 K
品牌: MICROCHIP [ MICROCHIP TECHNOLOGY ]
 浏览型号TCN75AVUA的Datasheet PDF文件第7页浏览型号TCN75AVUA的Datasheet PDF文件第8页浏览型号TCN75AVUA的Datasheet PDF文件第9页浏览型号TCN75AVUA的Datasheet PDF文件第10页浏览型号TCN75AVUA的Datasheet PDF文件第12页浏览型号TCN75AVUA的Datasheet PDF文件第13页浏览型号TCN75AVUA的Datasheet PDF文件第14页浏览型号TCN75AVUA的Datasheet PDF文件第15页  
TCN75A
5.3
Registers
Resolution
One-Shot
Shutdown
Fault Queue
Alert Polarity
Alert Comp/Int
Configuration
Register
Temperature
Register
T
HYST
Register
T
SET
Register
ALERT Output
Control Logic
ALERT
Output
The TCN75A has four registers that are user-accessi-
ble. These registers are specified as the Ambient
Temperature (T
A
) register, the Temperature Limit-set
(T
SET
) register, the Temperature Hysteresis (T
HYST
)
register and device Configuration (CONFIG) register.
The Ambient Temperature register is a read-only
register and is used to access the ambient temperature
data. The data from the ADC is loaded in parallel in the
register. The Temperature Limit-set and Temperature
Hysteresis registers are read/write registers that
provide user-programmable temperature limits. If the
ambient temperature drifts beyond the programmed
limits, the TCN75A outputs an alert signal using the
ALERT pin (refer to
The device Configuration register
provides access for the user to configure the TCN75A’s
various features. These registers are described in
further detail in the following sections.
The registers are accessed by sending register
pointers to the TCN75A using the serial interface. This
is an 8-bit pointer. However, the two Least Significant
bits (LSbs) are used as pointers and all other bits need
to be cleared <0>. This device has additional registers
that are reserved for test and calibration. If these
registers are accessed, the device may not perform
according to the specification. The pointer description
is shown below.
FIGURE 4-2:
Register Block Diagram.
REGISTER 5-1:
U-0
0
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 7-3
bit 2-0
REGISTER POINTER
U-0
0
U-0
0
U-0
0
U-0
0
U-0
0
R/W-0
P1
R/W-0
P0
bit 0
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
Unimplemented:
Read as ‘0’
Pointer
bits
00
= Temperature register (T
A
)
01
= Configuration register (CONFIG)
10
= Temperature Hysteresis register (T
HYST
)
11
= Temperature Limit-set register (T
SET
)
.
©
2006 Microchip Technology Inc.
DS21935C-page 11