PIC18F2480/2580/4480/4580
10.2 PIR Registers
Note 1: Interrupt flag bits are set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the global
interrupt enable bit, GIE (INTCON<7>).
The PIR registers contain the individual flag bits for the
peripheral interrupts. Due to the number of peripheral
interrupt sources, there are two Peripheral Interrupt
Request (Flag) registers (PIR1, PIR2).
2: User software should ensure the appropri-
ate interrupt flag bits are cleared prior to
enabling an interrupt and after servicing
that interrupt.
REGISTER 10-4: PIR1: PERIPHERAL INTERRUPT REQUEST (FLAG) REGISTER 1
R/W-0
PSPIF(1)
R/W-0
ADIF
R-0
R-0
R/W-0
SSPIF
R/W-0
R/W-0
R/W-0
RCIF
TXIF
CCP1IF
TMR2IF
TMR1IF
bit 7
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
PSPIF: Parallel Slave Port Read/Write Interrupt Flag bit(1)
1= A read or a write operation has taken place (must be cleared in software)
0= No read or write has occurred
ADIF: A/D Converter Interrupt Flag bit
1= An A/D conversion completed (must be cleared in software)
0= The A/D conversion is not complete
RCIF: EUSART Receive Interrupt Flag bit
1= The EUSART receive buffer, RCREG, is full (cleared when RCREG is read)
0= The EUSART receive buffer is empty
TXIF: EUSART Transmit Interrupt Flag bit
1= The EUSART transmit buffer, TXREG, is empty (cleared when TXREG is written)
0= The EUSART transmit buffer is full
SSPIF: Master Synchronous Serial Port Interrupt Flag bit
1= The transmission/reception is complete (must be cleared in software)
0= Waiting to transmit/receive
CCP1IF: CCP1 Interrupt Flag bit
Capture mode:
1= A TMR1 register capture occurred (must be cleared in software)
0= No TMR1 register capture occurred
Compare mode:
1= A TMR1 register compare match occurred (must be cleared in software)
0= No TMR1 register compare match occurred
PWM mode:
Unused in this mode.
bit 1
bit 0
TMR2IF: TMR2 to PR2 Match Interrupt Flag bit
1= TMR2 to PR2 match occurred (must be cleared in software)
0= No TMR2 to PR2 match occurred
TMR1IF: TMR1 Overflow Interrupt Flag bit
1= TMR1 register overflowed (must be cleared in software)
0= TMR1 register did not overflow
Note 1: This bit is reserved on PIC18F2X80 devices; always maintain this bit clear.
DS39637D-page 124
© 2009 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
