欢迎访问ic37.com |
会员登录 免费注册
发布采购

PIC18F4520-I/PT 参数 Datasheet PDF下载

PIC18F4520-I/PT图片预览
型号: PIC18F4520-I/PT
PDF下载: 下载PDF文件 查看货源
内容描述: 28 /40/ 44引脚增强型闪存微控制器与10位A / D和纳瓦技术 [28/40/44-Pin Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology]
分类和应用: 闪存微控制器
文件页数/大小: 412 页 / 6898 K
品牌: MICROCHIP [ MICROCHIP ]
 浏览型号PIC18F4520-I/PT的Datasheet PDF文件第148页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第149页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第150页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第151页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第153页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第154页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第155页浏览型号PIC18F4520-I/PT的Datasheet PDF文件第156页  
PIC18F2420/2520/4420/4520  
16.4.2  
PWM DUTY CYCLE  
EQUATION 16-3:  
The PWM duty cycle is specified by writing to the  
CCPR1L register and to the CCP1CON<5:4> bits. Up  
to 10-bit resolution is available. The CCPR1L contains  
the eight MSbs and the CCP1CON<5:4> bits contain  
the two LSbs. This 10-bit value is represented by  
CCPR1L:CCP1CON<5:4>. The PWM duty cycle is  
calculated by the following equation.  
FOSC  
FPWM  
log  
(
)
bits  
PWM Resolution (max) =  
log(2)  
Note:  
If the PWM duty cycle value is longer than  
the PWM period, the CCP1 pin will not be  
cleared.  
EQUATION 16-2:  
PWM Duty Cycle = (CCPR1L:CCP1CON<5:4>) •  
TOSC • (TMR2 Prescale Value)  
16.4.3  
PWM OUTPUT CONFIGURATIONS  
The P1M<1:0> bits in the CCP1CON register allow one  
of four configurations:  
CCPR1L and CCP1CON<5:4> can be written to at any  
time, but the duty cycle value is not copied into  
CCPR1H until a match between PR2 and TMR2 occurs  
(i.e., the period is complete). In PWM mode, CCPR1H  
is a read-only register.  
• Single Output  
• Half-Bridge Output  
• Full-Bridge Output, Forward mode  
• Full-Bridge Output, Reverse mode  
The CCPR1H register and a 2-bit internal latch are  
used to double-buffer the PWM duty cycle. This  
double-buffering is essential for glitchless PWM opera-  
tion. When the CCPR1H and 2-bit latch match TMR2,  
concatenated with an internal 2-bit Q clock or two bits  
of the TMR2 prescaler, the CCP1 pin is cleared. The  
maximum PWM resolution (bits) for a given PWM  
frequency is given by the following equation.  
The Single Output mode is the standard PWM mode  
discussed in Section 16.4 “Enhanced PWM Mode”.  
The Half-Bridge and Full-Bridge Output modes are  
covered in detail in the sections that follow.  
The general relationship of the outputs in all  
configurations is summarized in Figure 16-2 and  
Figure 16-3.  
TABLE 16-2: EXAMPLE PWM FREQUENCIES AND RESOLUTIONS AT 40 MHz  
PWM Frequency  
2.44 kHz  
9.77 kHz  
39.06 kHz 156.25 kHz 312.50 kHz 416.67 kHz  
Timer Prescaler (1, 4, 16)  
PR2 Value  
16  
FFh  
10  
4
1
1
3Fh  
8
1
1Fh  
7
1
FFh  
10  
FFh  
10  
17h  
6.58  
Maximum Resolution (bits)  
DS39631E-page 150  
© 2008 Microchip Technology Inc.  
 复制成功!