欢迎访问ic37.com |
会员登录 免费注册
发布采购

PIC18F2450-I/SO 参数 Datasheet PDF下载

PIC18F2450-I/SO图片预览
型号: PIC18F2450-I/SO
PDF下载: 下载PDF文件 查看货源
内容描述: 28 /40/ 44引脚,高性能, 12 MIPS ,增强型闪存, USB微控制器采用纳瓦技术 [28/40/44-Pin, High-Performance, 12 MIPS, Enhanced Flash, USB Microcontrollers with nanoWatt Technology]
分类和应用: 闪存微控制器和处理器外围集成电路光电二极管PC时钟
文件页数/大小: 320 页 / 5591 K
品牌: MICROCHIP [ MICROCHIP ]
 浏览型号PIC18F2450-I/SO的Datasheet PDF文件第151页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第152页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第153页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第154页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第156页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第157页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第158页浏览型号PIC18F2450-I/SO的Datasheet PDF文件第159页  
PIC18F2450/4450  
The pins of the Enhanced USART are multiplexed with  
PORTC. In order to configure RC6/TX/CK and RC7/RX/  
DT as an EUSART:  
15.0 ENHANCED UNIVERSAL  
SYNCHRONOUS RECEIVER  
TRANSMITTER (EUSART)  
• bit SPEN (RCSTA<7>) must be set (= 1)  
• bit TRISC<7> must be set (= 1)  
The Universal Synchronous Asynchronous Receiver  
Transmitter (USART) module is one of the two serial  
I/O modules. (USART is also known as a Serial  
Communications Interface or SCI.) The USART can be  
configured as a full-duplex asynchronous system that  
can communicate with peripheral devices, such as  
CRT terminals and personal computers. It can also be  
configured as a half-duplex synchronous system that  
can communicate with peripheral devices, such as A/D  
or D/A integrated circuits, serial EEPROMs and so on.  
• bit TRISC<6> must be cleared (= 0) for  
Asynchronous and Synchronous Master modes  
or set (= 1) for Synchronous Slave mode  
Note:  
The EUSART control will automatically  
reconfigure the pin from input to output as  
needed.  
The operation of the Enhanced USART module is  
controlled through three registers:  
The Enhanced Universal Synchronous Receiver  
Transmitter (EUSART) module implements additional  
features, including Automatic Baud Rate Detection  
(ABD) and calibration, automatic wake-up on Sync  
Break reception and 12-bit Break character transmit.  
These features make it ideally suited for use in Local  
Interconnect Network bus (LIN bus) systems.  
• Transmit Status and Control (TXSTA)  
• Receive Status and Control (RCSTA)  
• Baud Rate Control (BAUDCON)  
These are detailed on the following pages in  
Register 15-1, Register 15-2 and Register 15-3,  
respectively.  
The EUSART can be configured in the following  
modes:  
• Asynchronous (full-duplex) with:  
- Auto-wake-up on character reception  
- Auto-baud calibration  
- 12-bit Break character transmission  
• Synchronous – Master (half-duplex) with  
selectable clock polarity  
• Synchronous – Slave (half-duplex) with selectable  
clock polarity  
© 2006 Microchip Technology Inc.  
Advance Information  
DS39760A-page 153  
 复制成功!