PIC18F2331/2431/4331/4431
REGISTER 20-3: BAUDCON: BAUD RATE CONTROL REGISTER
U-0
—
R-1
U-0
—
R/W-1
SCKP
R/W-0
U-0
—
R/W-0
WUE
R/W-0
RCIDL
BRG16
ABDEN
bit 7
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
bit 7
bit 6
Unimplemented: Read as ‘0’
RCIDL: Receive Operation Idle Status bit
1= Receiver is Idle
0= Receive in progress
bit 5
bit 4
Unimplemented: Read as ‘0’
SCKP: Synchronous Clock Polarity Select bit
Asynchronous mode:
Unused in this mode.
Synchronous mode:
1= Idle state for clock (CK) is a high level
0= Idle state for clock (CK) is a low level
bit 3
BRG16: 16-Bit Baud Rate Register Enable bit
1= 16-bit Baud Rate Generator – SPBRGH and SPBRG
0= 8-bit Baud Rate Generator – SPBRG only (Compatible mode), SPBRGH value ignored
bit 2
bit 1
Unimplemented: Read as ‘0’
WUE: Wake-up Enable bit
Asynchronous mode:
1= EUSART will continue to sample the RX pin – interrupt generated on falling edge; bit cleared in
hardware on following rising edge
0= RX pin not monitored or rising edge detected
Synchronous mode:
Unused in this mode.
bit 0
ABDEN: Auto-Baud Detect Enable bit
Asynchronous mode:
1= Enable baud rate measurement on the next character – requires reception of a Sync field (55h);
cleared in hardware upon completion.
0= Baud rate measurement disabled or completed
Synchronous mode:
Unused in this mode.
DS39616D-page 220
2010 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
