PIC18F2220/2320/4220/4320
3.5.2
EXIT BY RESET
3.5.4
EXIT WITHOUT AN OSCILLATOR
START-UP DELAY
Normally, the device is held in Reset by the Oscillator
Start-up Timer (OST) until the primary clock (defined in
Configuration Register 1H) becomes ready. At that
time, the OSTS bit is set and the device begins
executing code.
Certain exits from power managed modes do not
invoke the OST at all. These are:
• PRI_IDLE mode, where the primary clock source
is not stopped; and
Code execution can begin before the primary clock
becomes ready. If either the Two-Speed Start-up (see
Section 23.3 “Two-Speed Start-up”) or Fail-Safe
Clock Monitor (see Section 23.4 “Fail-Safe Clock
Monitor”) are enabled in Configuration Register 1H,
the device may begin execution as soon as the Reset
source has cleared. Execution is clocked by the
INTOSC multiplexer driven by the internal oscillator
block. Since the OSCCON register is cleared following
all Resets, the INTRC clock source is selected. A higher
speed clock may be selected by modifying the IRCF bits
in the OSCCON register. Execution is clocked by the
internal oscillator block until either the primary clock
becomes ready, or a power managed mode is entered
before the primary clock becomes ready; the primary
clock is then shut down.
• the primary clock source is not any of the LP, XT,
HS or HSPLL modes.
In these cases, the primary clock source either does
not require an oscillator start-up delay, since it is
already running (PRI_IDLE), or normally does not
require an oscillator start-up delay (RC, EC and INTIO
Oscillator modes).
However, a fixed delay (approximately 10 µs) following
the wake-up event is required when leaving Sleep and
Idle modes. This delay is required for the CPU to pre-
pare for execution. Instruction execution resumes on
the first clock cycle following this delay.
3.6
INTOSC Frequency Drift
The factory calibrates the internal oscillator block
output (INTOSC) for 8 MHz. However, this frequency
may drift as VDD or temperature changes, which can
affect the controller operation in a variety of ways.
3.5.3
EXIT BY WDT TIME-OUT
A WDT time-out will cause different actions depending
on which power managed mode the device is in when
the time-out occurs.
It is possible to adjust the INTOSC frequency by modi-
fying the value in the OSCTUNE register. This has the
side effect that the INTRC clock source frequency is
also affected. However, the features that use the
INTRC source often do not require an exact frequency.
These features include the Fail-Safe Clock Monitor, the
Watchdog Timer and the RC_RUN/RC_IDLE modes
when the INTRC clock source is selected.
If the device is not executing code (all Idle modes and
Sleep mode), the time-out will result in a wake-up from
the power managed mode (see Section 3.2 “Sleep
Mode” through Section 3.4 “Run Modes”).
If the device is executing code (all Run modes), the
time-out will result in a WDT Reset (see Section 23.2
“Watchdog Timer (WDT)”).
The WDT timer and postscaler are cleared by execut-
ing a SLEEP or CLRWDT instruction, the loss of a
currently selected clock source (if the Fail-Safe Clock
Monitor is enabled) and modifying the IRCF bits in the
OSCCON register if the internal oscillator block is the
system clock source.
Being able to adjust the INTOSC requires knowing
when an adjustment is required, in which direction it
should be made and in some cases, how large a
change is needed. Three examples are shown but
other techniques may be used.
DS39599C-page 40
2003 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
