PIC18F2220/2320/4220/4320
remain low until the CKP bit is set and all other
devices on the I2C bus have deasserted SCL. This
ensures that a write to the CKP bit will not violate the
minimum high time requirement for SCL (see
Figure 17-12).
17.4.4.5
Clock Synchronization and
the CKP bit (SEN = 1)
The SEN bit is also used to synchronize writes to the
CKP bit. If a user clears the CKP bit, the SCL output is
forced to ‘0’. When the SEN bit is set to ‘1’, setting the
CKP bit will not assert the SCL output low until the
SCL output is already sampled low. If the user
attempts to drive SCL low, the CKP bit will not assert
the SCL line until an external I2C master device has
already asserted the SCL line. The SCL output will
Note:
If the SEN bit is ‘0’, clearing the CKP bit
will result in immediately driving the SCL
output to ‘0’ regardless of the current
state.
FIGURE 17-12:
CLOCK SYNCHRONIZATION TIMING
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
SDA
SCL
DX
DX-1
Master device
asserts clock
CKP
Master device
deasserts clock
WR
SSPCON1
2003 Microchip Technology Inc.
DS39599C-page 175
MICROCHIP [ MICROCHIP ]
