PIC16F7X7
7.0
TIMER1 MODULE
7.1
Timer1 Operation
The Timer1 module is a 16-bit timer/counter consisting
of two 8-bit registers (TMR1H and TMR1L) which are
readable and writable. The TMR1 register pair
(TMR1H:TMR1L) increments from 0000h to FFFFh
and rolls over to 0000h. The TMR1 interrupt, if enabled,
is generated on overflow which is latched in interrupt
flag bit, TMR1IF (PIR1<0>). This interrupt can be
enabled/disabled by setting/clearing TMR1 interrupt
enable bit, TMR1IE (PIE1<0>).
The Timer1 oscillator can be used as a secondary clock
source in low-power modes. When the T1RUN bit is set
along with SCS<1:0> =
01,
the Timer1 oscillator is pro-
viding the system clock. If the Fail-Safe Clock Monitor
is enabled and the Timer1 oscillator fails while
providing the system clock, polling the T1RUN bit will
indicate whether the clock is being provided by the
Timer1 oscillator or another source.
Timer1 can also be used to provide Real-Time Clock
(RTC) functionality to applications with only a minimal
addition of external components and code overhead.
Timer1 can operate in one of three modes:
• as a Timer
• as a Synchronous Counter
• as an Asynchronous Counter
The operating mode is determined by the clock select
bit, TMR1CS (T1CON<1>).
In Timer mode, Timer1 increments every instruction
cycle. In Counter mode, it increments on every rising
edge of the external clock input.
Timer1 can be enabled/disabled by setting/clearing
control bit, TMR1ON (T1CON<0>).
Timer1 also has an internal “Reset input”. This Reset
can be generated by the CCP1 module as the special
event trigger (see
When the Timer1 oscillator is enabled (T1OSCEN is
set), the RC0/T1OSO/T1CKI and RC1/T1OSI/CCP2
pins become inputs. That is, the TRISB<7:6> value is
ignored and these pins read as ‘0’.
Additional information on timer modules is available in
the
“PICmicro
®
Mid-Range MCU Family Reference
Manual”
(DS33023).
2004 Microchip Technology Inc.
DS30498C-page 77
MICROCHIP [ MICROCHIP TECHNOLOGY ]
