PIC16C71X
Applicable Devices 710 71 711 715
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0˚C
-40˚C
-40˚C
≤ TA ≤ +70˚C (commercial)
≤ TA ≤ +85˚C (industrial)
≤ TA ≤ +125˚C (extended)
DC CHARACTERISTICS
Operating voltage VDD range as described in DC spec Section 11.1 and
Section 11.2.
Param
No.
Characteristic
Sym
Min Typ Max Units
†
Conditions
Output Low Voltage
D080
I/O ports
VOL
-
-
-
-
-
-
-
-
0.6
0.6
0.6
0.6
V
V
V
V
IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
IOL = 7.0 mA, VDD = 4.5V,
-40°C to +125°C
IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
IOL = 1.2 mA, VDD = 4.5V,
-40°C to +125°C
D080A
D083
OSC2/CLKOUT (RC osc config)
D083A
Output High Voltage
D090
I/O ports (Note 3)
VOH VDD - 0.7 -
VDD - 0.7 -
-
-
V
V
V
V
V
IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D090A
D092
OSC2/CLKOUT (RC osc config)
VDD - 0.7 -
-
D092A
D130*
VDD - 0.7 -
-
Open-Drain High Voltage
Capacitive Loading Specs on
Output Pins
VOD
-
-
-
-
-
-
14
RA4 pin
D100
D101
OSC2 pin
COSC2
15
50
pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
All I/O pins and OSC2 (in RC mode) CIO
pF
*
These parameters are characterized but not tested.
†
Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C7X be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
1997 Microchip Technology Inc.
DS30272A-page 93
MICROCHIP [ MICROCHIP ]
