PIC16C5X
PIC16C58A
16.2
DC Characteristics: PIC16C58A-04E, 10E, 20E (Extended)
DC Characteristics
Power Supply Pins
Standard Operating Conditions (unless otherwise specified)
Operating Temperature
–40°C ≤ TA ≤ +125°C (extended)
(1)
Characteristic
Sym Min Typ
Max Units Conditions
Supply Voltage
XT and RC options
HS option
VDD
3.5
4.5
—
—
5.5
5.5
V
V
(2)
RAM Data Retention Voltage
VDR
—
—
1.5*
VSS
—
—
V
V
Device in SLEEP mode
VDD start voltage to ensure
Power-On Reset
VPOR
See Section 7.4 for details on
Power-on Reset
VDD rise rate to ensure
Power-On Reset
SVDD
IDD
0.05*
—
—
V/ms See Section 7.4 for details on
Power-on Reset
(3)
Supply Current
(4)
XT and RC options
—
—
—
1.9
4.8
9.0
3.3 mA FOSC = 4.0 MHz, VDD = 5.5V
10
20
HS option
mA FOSC = 10 MHz, VDD = 5.5V
mA FOSC = 20 MHz, VDD = 5.5V
(5)
Power Down Current
IPD
XT and RC options
—
—
—
—
5.0
0.8
4.0
22
18
22
18
µA VDD = 3.5V, WDT enabled
µA VDD = 3.5V, WDT disabled
µA VDD = 3.5V, WDT enabled
µA VDD = 3.5V, WDT disabled
HS option
0.25
* These parameters are characterized but not tested.
Note 1: Data in the Typical (“Typ”) column is based on characterization results at 25°C. This data is for design
guidance only and is not tested.
2: This is the limit to which VDD can be lowered in SLEEP mode without losing RAM data.
3: The supply current is mainly a function of the operating voltage and frequency. Other factors such as bus
loading, oscillator type, bus rate, internal code execution pattern, and temperature also have an impact on
the current consumption.
a) The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tristated, pulled to
Vss, T0CKI = VDD, MCLR = VDD; WDT enabled/disabled as specified.
b) For standby current measurements, the conditions are the same, except that
the device is in SLEEP mode.
4: Does not include current through Rext. The current through the resistor can be estimated by the
formula: IR = VDD/2Rext (mA) with Rext in kΩ.
5: The power down current in SLEEP mode does not depend on the oscillator type. Power down current is
measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD and VSS.
DS30453B-page 134
Preliminary
1998 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
