PIC16C745/765
CCP2 Module:
9.0
CAPTURE/COMPARE/PWM
MODULES
Capture/Compare/PWM Register1 (CCPR2) is com-
prised of two 8-bit registers: CCPR2L (low byte) and
CCPR2H (high byte). The CCP2CON register controls
the operation of CCP2. The special event trigger is gen-
erated by a compare match and will reset Timer1 and
start an A/D conversion (if the A/D module is enabled).
Each Capture/Compare/PWM (CCP) module contains
a 16-bit register which can operate as a:
• 16-bit capture register
• 16-bit compare register
• PWM master/slave Duty Cycle register
Additional information on CCP modules is available in
the PICmicro™ Mid-Range MCU Family Reference
Manual (DS33023) and in “Using the CCP Modules”
(AN594).
Both the CCP1 and CCP2 modules are identical in
operation, with the exception being the operation of the
special event trigger. Table 9-1 and Table 9-2 show the
resources and interactions of the CCP module(s). In
the following sections, the operation of a CCP module
is described with respect to CCP1. CCP2 operates the
same as CCP1, except where noted.
TABLE 9-1:
CCP MODE - TIMER
RESOURCES REQUIRED
CCP Mode
Timer Resource
CCP1 Module:
Capture
Compare
PWM
Timer1
Timer1
Timer2
Capture/Compare/PWM Register1 (CCPR1) is com-
prised of two 8-bit registers: CCPR1L (low byte) and
CCPR1H (high byte). The CCP1CON register controls
the operation of CCP1. The special event trigger is gen-
erated by a compare match and will reset Timer1.
TABLE 9-2:
INTERACTION OF TWO CCP MODULES
CCPx Mode CCPy Mode
Interaction
Capture
Capture
Compare
PWM
Capture
Compare
Compare
PWM
Same TMR1 time-base.
The compare should be configured for the special event trigger, which clears TMR1.
The compare(s) should be configured for the special event trigger, which clears TMR1.
The PWMs will have the same frequency and update rate (TMR2 interrupt).
PWM
Capture
Compare
None.
None.
PWM
1999 Microchip Technology Inc.
Advanced Information
DS41124A-page 51
MICROCHIP [ MICROCHIP ]
