PIC16F7X
It may be advantageous to use the high baud rate
(BRGH = 1), even for slower baud clocks. This is
because the FOSC/(16(X + 1)) equation can reduce the
baud rate error in some cases.
10.1 USART Baud Rate Generator
(BRG)
The BRG supports both the Asynchronous and Syn-
chronous modes of the USART. It is a dedicated 8-bit
baud rate generator. The SPBRG register controls the
period of a free running 8-bit timer. In Asynchronous
mode, bit BRGH (TXSTA<2>) also controls the baud
rate. In Synchronous mode, bit BRGH is ignored.
Table 10-1 shows the formula for computation of the
baud rate for different USART modes which only apply
in Master mode (internal clock).
Writing a new value to the SPBRG register causes the
BRG timer to be reset (or cleared). This ensures the
BRG does not wait for a timer overflow before output-
ting the new baud rate.
10.1.1
SAMPLING
The data on the RC7/RX/DT pin is sampled three times
by a majority detect circuit to determine if a high or a
low level is present at the RX pin.
Given the desired baud rate and FOSC, the nearest
integer value for the SPBRG register can be calculated
using the formula in Table 10-1. From this, the error in
baud rate can be determined.
TABLE 10-1: BAUD RATE FORMULA
SYNC
BRGH = 0 (Low Speed)
BRGH = 1 (High Speed)
0
1
(Asynchronous) Baud Rate = FOSC/(64(X+1))
(Synchronous) Baud Rate = FOSC/(4(X+1))
Baud Rate = FOSC/(16(X+1))
N/A
X = value in SPBRG (0 to 255)
TABLE 10-2: REGISTERS ASSOCIATED WITH BAUD RATE GENERATOR
Value on:
POR,
BOR
Value on
all other
RESETS
Address Name
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1 Bit 0
0000 -010 0000 -010
0000 -00x 0000 -00x
0000 0000 0000 0000
98h
18h
99h
TXSTA
CSRC TX9 TXEN SYNC
—
—
BRGH TRMT TX9D
FERR OERR RX9D
RCSTA SPEN RX9 SREN CREN
SPBRG Baud Rate Generator Register
Legend: x= unknown, -= unimplemented, read as '0'. Shaded cells are not used by the BRG.
2002 Microchip Technology Inc.
DS30325B-page 71
MICROCHIP [ MICROCHIP ]
