PIC16F7X
15.2 DC Characteristics: PIC16F73/74/76/77 (Industrial, Extended)
PIC16LF73/74/76/77 (Industrial) (Continued)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
DC CHARACTERISTICS
Param
Operating voltage VDD range as described in DC Specification,
Section 15.1.
Sym
Characteristic
Min
Typ† Max Units
Conditions
No.
VOL
Output Low Voltage
D080
D083
I/O ports
—
—
0.6
V
IOL = 8.5 mA, VDD = 4.5V,
-40°C to +125°C
IOL = 1.6 mA, VDD = 4.5V,
-40°C to +125°C
IOL = 1.2 mA, VDD = 4.5V,
-40°C to +125°C
OSC2/CLKOUT (RC osc config)
—
—
—
—
0.6
0.6
V
V
VOH
Output High Voltage
D090
D092
I/O ports (Note 3)
VDD - 0.7
—
—
V
IOH = -3.0 mA, VDD = 4.5V,
-40°C to +125°C
OSC2/CLKOUT (RC osc config) VDD - 0.7
VDD - 0.7
—
—
—
—
V
V
IOH = -1.3 mA, VDD = 4.5V,
-40°C to +125°C
IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D150* VOD Open Drain High Voltage
—
—
—
12
15
V
RA4 pin
Capacitive Loading Specs on Output Pins
D100
COSC2 OSC2 pin
—
pF In XT, HS and LP modes when
external clock is used to drive
OSC1
D101
D102
CIO
CB
All I/O pins and OSC2
(in RC mode)
—
—
—
—
50
pF
SCL, SDA in I2C mode
Program FLASH Memory
Endurance
400
pF
D130
D131
EP
100
2.0
1000
—
E/W 25°C at 5V
VPR
VDD for Read
—
5.5
V
*
These parameters are characterized but not tested.
†
Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16F7X be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
DS30325B-page 124
2002 Microchip Technology Inc.
MICROCHIP [ MICROCHIP ]
