PIC16F62X
4.2.2.3
INTCON REGISTER
Note: Interrupt flag bits get set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the global
enable bit, GIE (INTCON<7>).
The INTCON register is a readable and writable
register which contains the various enable and flag bits
for all interrupt sources except the comparator module.
See Section 4.2.2.4 and Section 4.2.2.5 for
description of the comparator enable and flag bits.
a
REGISTER 4-3: INTCON REGISTER (ADDRESS 0BH OR 8BH)
R/W-0
GIE
R/W-0
PEIE
R/W-0
T0IE
R/W-0
INTE
R/W-0
RBIE
R/W-0
T0IF
R/W-0
INTF
R/W-x
RBIF
bit0
R = Readable bit
W = Writable bit
bit7
U = Unimplemented bit, read
as ’0’
-n = Value at POR reset
-x = Unknown at POR reset
bit 7:
GIE: Global Interrupt Enable bit
1= Enables all un-masked interrupts
0= Disables all interrupts
bit 6:
bit 5:
bit 4:
bit 3:
bit 2:
bit 1:
bit 0:
PEIE: Peripheral Interrupt Enable bit
1= Enables all un-masked peripheral interrupts
0= Disables all peripheral interrupts
T0IE: TMR0 Overflow Interrupt Enable bit
1= Enables the TMR0 interrupt
0= Disables the TMR0 interrupt
INTE: RB0/INT External Interrupt Enable bit
1= Enables the RB0/INT external interrupt
0= Disables the RB0/INT external interrupt
RBIE: RB Port Change Interrupt Enable bit
1= Enables the RB port change interrupt
0= Disables the RB port change interrupt
T0IF: TMR0 Overflow Interrupt Flag bit
1= TMR0 register has overflowed (must be cleared in software)
0= TMR0 register did not overflow
INTF: RB0/INT External Interrupt Flag bit
1= The RB0/INT external interrupt occurred (must be cleared in software)
0= The RB0/INT external interrupt did not occur
RBIF: RB Port Change Interrupt Flag bit
1= When at least one of the RB7:RB4 pins changed state (must be cleared in software)
0= None of the RB7:RB4 pins have changed state
1999 Microchip Technology Inc.
Preliminary
DS40300B-page 21
MICROCHIP [ MICROCHIP ]
