PIC12F629/675
After the analog input channel is selected (changed),
this acquisition must be done before the conversion
can be started.
7.2
A/D Acquisition Requirements
For the A/D converter to meet its specified accuracy,
the charge holding capacitor (CHOLD) must be allowed
to fully charge to the input channel voltage level. The
analog input model is shown in Figure 7-3. The source
impedance (RS) and the internal sampling switch (RSS)
impedance directly affect the time required to charge
the capacitor CHOLD. The sampling switch (RSS)
impedance varies over the device voltage (VDD), see
Figure 7-3. The maximum recommended imped-
ance for analog sources is 10 kΩ. As the impedance
is decreased, the acquisition time may be decreased.
To calculate the minimum acquisition time,
Equation 7-± may be used. This equation assumes
that ±/2 LSb error is used (±024 steps for the A/D).
The ±/2 LSb error is the maximum error allowed for
the A/D to meet its specified resolution.
To calculate the minimum acquisition time, TACQ, see
the PICmicro™ Mid-Range Reference Manual
(DS33023).
EQUATION 7-1:
ACQUISITION TIME
TACQ
= Amplifier Settling Time +
Hold Capacitor Charging Time +
Temperature Coefficient
= TAMP + TC + TCOFF
= 2µs + TC + [(Temperature -25°C)(0.05µs/°C)]
= CHOLD (RIC + RSS + RS) In(1/2047)
= - 120pF (1kΩ + 7kΩ + 10kΩ) In(0.0004885)
= 16.47µs
TC
TACQ
= 2µs + 16.47µs + [(50°C -25°C)(0.05µs/°C)
= 19.72µs
Note 1: The reference voltage (VREF) has no effect on the equation, since it cancels itself out.
2: The charge holding capacitor (CHOLD) is not discharged after each conversion.
3: The maximum recommended impedance for analog sources is ±0 kΩ. This is required to meet the pin
leakage specification.
FIGURE 7-3:
ANALOG INPUT MODEL
VDD
Sampling
Switch
VT = 0.6V
ANx
SS
RIC ≤ 1K
RSS
RS
CHOLD
= DAC capacitance
= 120 pF
CPIN
5 pF
VA
I LEAKAGE
500 nA
VT = 0.6V
VSS
Legend CPIN
VT
= input capacitance
= threshold voltage
6V
5V
VDD 4V
3V
2V
I LEAKAGE = leakage current at the pin due to
various junctions
RIC
SS
CHOLD
= interconnect resistance
= sampling switch
= sample/hold capacitance (from DAC)
5 6 7 8 9 1011
Sampling Switch
(kΩ)
2003 Microchip Technology Inc.
DS41190C-page 45
MICROCHIP [ MICROCHIP ]
