• ADC10/ACMP1/PCINT14 – Bit 6
ADC10, analog to digital converter, input channel 10.
ACMP1, analog comparator 1 positive input. Configure the port pin as input with the internal pull-up switched off to avoid the
digital port function from interfering with the function of the analog comparator.
PCINT14, pin change interrupt 14.
• ADC9/ACMP3/AMP1+/PCINT13 – Bit 5
ADC9, analog to digital converter, input channel 9.
ACMP3, analog comparator 3 positive input. Configure the port pin as input with the internal pull-up switched off to avoid the
digital port function from interfering with the function of the analog comparator.
AMP1+, analog differential amplifier 1 positive input channel. Configure the port pin as input with the internal pull-up
switched off to avoid the digital port function from interfering with the function of the analog amplifier.
PCINT13, pin change interrupt 13.
• ADC8/AMP1-/ACMPN3/PCINT12 – Bit 4
ADC8, analog to digital converter, input channel 8.
AMP1-, analog differential amplifier 1 negative input channel. Configure the port pin as input with the internal pull-up
switched off to avoid the digital port function from interfering with the function of the analog amplifier.
ACMPN3, analog comparator 3 negative input. Configure the port pin as input with the internal pull-up switched off to avoid
the digital port function from interfering with the function of the analog comparator.
PCINT12, pin change interrupt 12.
• PCINT11/T1/RXCAN/ICP1B – Bit 3
T1, Timer/Counter1 counter source.
RXCAN, CAN Rx data.
ICP1B, input capture pin: The PC3 pin can act as an input capture pin for Timer/Counter1.
PCINT11, pin change interrupt 11.
• PCINT10/T0/TXCAN – Bit 2
T0, Timer/Counter0 counter source.
TXCAN, CAN Tx data.
PCINT10, pin change interrupt 10.
• PCINT9/PSCIN1/OC1B/SS_A – Bit 1
PCSIN1, PSC 1 digital input.
OC1B, output compare match B output: This pin can serve as an external output for the Timer/Counter1 output compare B.
The pin has to be configured as an output (DDC1 set “one”) to serve this function. This pin is also the output pin for the PWM
mode timer function.
SS_A: Slave port select input. When the SPI is enabled as a slave, this pin is configured as an input regardless of the setting
of DDD0. As a slave, the SPI is activated when this pin is driven low. When the SPI is enabled as a master, the data direction
of this pin is controlled by DDD0. When the pin is forced to be an input, the pull-up can still be controlled by the PORTD0 bit.
PCINT9, pin change interrupt 9.
• PCINT8/PSCOUT1A/INT3 – Bit 0
PSCOUT1A, output 1A of PSC.
INT3, external interrupt source 3: This pin can serve as an external interrupt source to the MCU.
PCINT8, pin change interrupt 8.
62
ATmega16/32/64/M1/C1 [DATASHEET]
7647O–AVR–01/15
MICROCHIP [ MICROCHIP ]
