ML4894
DESIGN CONSIDERATIONS (cont.)
INPUT CAPACITOR SELECTION
OUTPUT CAPACITOR SELECTION
The choice of the input capacitor is based on its ripple
current and voltage ratings rather than its capacitance
value. The input capacitor should be a low ESR type and
located as close to the source of the P-MOS switch as
possible. The input capacitor’s ripple current is
The output capacitors determine the loop stability and the
output ripple voltage. Use only low ESR capacitors
intended for switching power supply applications, such as
AVX TPS, Sprague 593D, Sanyo OS-CON, or Nichicon PL
series. To ensure stability, the minimum capacitance value
is given by:
determined by the load current and input voltage, with
the worst case condition occurring atV = 2 x V
:
IN
OUT
TON(MAX)
4.3
COUT
≥
×
(14)
5V × V − 5V
b
g
IN
1
2
VOUT
RSENSE
IRMS(C ≈ (ISENSE(MAX)
+
∆IL(MAX) ) ×
)
IN
VIN
The maximum ESR value can be estimated using:
The capacitor’s voltage rating is based on the maximum
input voltage, V . Capacitor manufacturers typically
recommend derating the capacitor voltage rating by 20%
to 50% for aluminum electrolytic types and 50% to 70%
for tantalum types.
∆VOUT
ESR ≤
IN(MAX)
(15)
∆IL(MAX)
The selected capacitor must meet both the capacitance
and ESR requirements. As a final check, make sure the
output capacitor can handle the ripple current, I
In high current applications it may necessary to add a
:
RMS
small 0.1µF ceramic capacitor to bypass V (pin 8) of the
IN
∆IL(MAX)
ML4894.
IRMS
≈
(16)
12
8
MICRO-LINEAR [ MICRO LINEAR CORPORATION ]
