ML2722
27
29
31
RVCC6
RVCC7
VDD
O (Analog)
O (Analog)
I (Digital)
DC power supply decoupling point for
Quadrature Mixer and IF filter circuits. A
capacitor must be tied between this pin
and ground to decouple (bypass) noise
and to stabilize the regulator.
DC power supply decoupling point for IF,
Demodulator, and Data Slicer circuits. A
capacitor must be tied between this pin
and ground to decouple (bypass) noise
and to stabilize the regulator.
DC power supply input to the interface
logic and control registers. This supply is
not connected internally to any other
supply pin, but its voltage must be less
than or equal to the VCC5 supply and
greater than 2.7V. A capacitor must be
tied between this pin and ground to
decouple (bypass) noise.
TRANSMIT/RECEIVE
21 RRFI
VCC5
24
I (Analog)
Receive RF Input. Nominal impedance at
902 to 928MHz is 17-50j Ω with a simple
matching network required for optimum
noise figure. This input is to the base of
an NPN transistor and should be AC
coupled.
0.7V
4k
RRFI 21
(PIN 8)
VSS
VCC5 (PIN 24)
GND
18
8
VSS
DS2722-F-06
FINAL DATASHEET
DECEMBER 2005
8
MICRO-LINEAR [ MICRO LINEAR CORPORATION ]
