DS18B20-PAR
transmitted least significant bit first. All three bytes MUST be written before the master issues a reset, or
the data may be corrupted.
READ SCRATCHPAD [BEh]
This command allows the master to read the contents of the scratchpad. The data transfer starts with the
least significant bit of byte 0 and continues through the scratchpad until the 9th byte (byte 8 – CRC) is
read. If only part of the scratchpad contents is required, the master may issue a reset to terminate reading
at any time.
COPY SCRATCHPAD [48h]
This command copies the contents of the scratchpad TH, TL and configuration registers (bytes 2, 3 and 4)
to EEPROM. Within 10 μs (max) after this command is issued the master must enable a strong pullup on
the 1-Wire bus for at least 10 ms as described in the PARASITE POWER section.
RECALL E2 [B8h]
This command recalls the alarm trigger values (TH and TL) and configuration data from EEPROM and
places the data in bytes 2, 3, and 4, respectively, in the scratchpad memory. The master device can issue
“read time slots” (see the 1-WIRE BUS SYSTEM section) following the Recall E2 command and the
DS18B20-PAR will indicate the status of the recall by transmitting 0 while the recall is in progress and
1 when the recall is done. The recall operation happens automatically at power-up, so valid data is
available in the scratchpad as soon as power is applied to the device.
DS18B20-PAR Function Command Set Table 4
1-Wire Bus Activity
Command
Convert T
Description
Protocol After Command is Issued Notes
TEMPERATURE CONVERSION COMMANDS
Initiates temperature
conversion.
44h
None
1
MEMORY COMMANDS
Read Scratchpad
Reads the entire scratchpad
including the CRC byte.
BEh
DS18B20-PAR transmits up
to 9 data bytes to master.
Master transmits 3 data
bytes to DS18B20-PAR.
2
3
Write Scratchpad Writes data into scratchpad
bytes 2, 3, and 4 (TH, TL, and
4Eh
configuration registers).
Copy Scratchpad Copies TH, TL, and
configuration register data from
the scratchpad to EEPROM.
48h
None
1
Recall E2
Recalls TH, TL, and
configuration register data from
EEPROM to the scratchpad.
B8h
DS18B20-PAR transmits
recall status to master.
NOTES:
1. The master must enable a strong pullup on the 1-Wire bus during temperature conversions and copies
from the scratchpad to EEPROM. No other bus activity may take place during this time.
2. The master can interrupt the transmission of data at any time by issuing a reset.
3. All three bytes must be written before a reset is issued.
10 of 19
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
