Real-Time Clock
5/DS12C87A
Pin Description (continued)
PIN
PLCC
SO,
PDIP
NAME
FUNCTION
EDIP
TQFP
4, 6, 10,
15, 20,
23, 25,
27, 32
2, 3,
16, 20, 13, 18,
21, 22
1, 11,
No Connection. This pin should remain unconnected. Pin 21 is RCLR for the
DS12887A/DS12C887A. On the EDIP, these pins are missing by design.
22
N.C.
26
Data Strobe or Read Input. The DS pin has two modes of operation depending on
the level of the MOT pin. When the MOT pin is connected to V , Motorola bus
CC
timing is selected. In this mode, DS is a positive pulse during the latter portion of the
bus cycle and is called data strobe. During read cycles, DS signifies the time that the
device is to drive the bidirectional bus. In write cycles, the trailing edge of DS causes
the device to latch the written data. When the MOT pin is connected to GND, Intel
bus timing is selected. DS identifies the time period when the device drives the bus
with read data. In this mode, the DS pin operates in a similar fashion as the output-
enable (OE ) signal on a generic RAM.
17
17
21
18
DS
Active-Low Reset Input. The RESET pin has no effect on the clock, calendar, or
RAM. On power-up, the RESET pin can be held low for a time to allow the power
supply to stabilize. The amount of time that RESET is held low is dependent on the
application. However, if RESET is used on power-up, the time RESET is low should
exceed 200ms to ensure that the internal timer that controls the device on power-
up has timed out. When RESET is low and V
is above V , the following occurs:
PF
CC
A. Periodic interrupt-enable (PIE) bit is cleared to 0.
B. Alarm interrupt-enable (AIE) bit is cleared to 0.
C. Update-ended interrupt-enable (UIE) bit is cleared to 0.
D. Periodic-interrupt flag (PF) bit is cleared to 0.
E. Alarm-interrupt flag (AF) bit is cleared to 0.
18
18
22
19
RESET
F. Update-ended interrupt flag (UF) bit is cleared to 0.
G. Interrupt-request status flag (IRQF) bit is cleared to 0.
H. IRQ pin is in the high-impedance state.
I. The device is not accessible until RESET is returned high.
J. Square-wave output-enable (SQWE) bit is cleared to 0.
In a typical application, RESET can be connected to V . This connection allows
CC
the device to go in and out of power fail without affecting any of the control
registers.
_____________________________________________________________________
9
MAXIM [ MAXIM INTEGRATED PRODUCTS ]
