DA6116.001
27 February, 2009
ABSOLUTE MAXIMUM RATINGS
All voltages with respect to ground.
Parameter
Symbol
Conditions
Min
-20
Max
+20
Unit
V
Signal Voltage
RIN, RFO, LIN, LFO
AVCC, DVCC
Positive Supply Voltage
All other pins
-0.5
-0.3
+6.0
V
DATA, CLK, XCS,
XMUTE
TS
Note 3.
AVCC
+0.3
+125
V
Storage Temperature
-55
-40
oC
oC
V
Operating Temperature
ESD (HBM) pins 3, 4, 13 and 14
ESD (HBM) all other pins
TA
+95
200
2000
V
Note 3. Pin voltage must not exceed +6V under any circumstances.
Stresses beyond those listed may cause permanent damage to the device. The device may not operate under these conditions, but it will not
be destroyed.
RECOMMENDED OPERATION CONDITIONS
(AVCC=+5.0 V, AGND=0 V, TA=+25oC unless otherwise noted)
Parameter
Symbol
Conditions
Min
Typ
Max
Unit
Signal Voltage
RIN, RFO, LIN,
LFO
AVCC,DVCC
-18
+18
V
Positive Supply Voltage
Negative Supply Voltage
Signal Grounds
4.5
-30
5
0
5.5
V
V
AGND,DGND
LGND,RGND
TA
0
V
oC
Operating Temperature
+25
+85
ANALOG CHARACTERISTICS
N Analog Inputs/Outputs
(AVCC=+5.0 V, AGND=0 V, TA=+25oC unless otherwise noted)
Parameter
Symbol
RIN
Conditions
Min
Typ
10
Max
Unit
Input impedance
Input capacitance
Input offset voltage
Average impedance, note 4
For any gain value
7
13
kΩ
pF
CIN
2
VIH
External OpAmp,
Gain = 15.5 dB
Note 5
0.23
mV
Supply current
Supply current
Power supply
rejection ratio1
IVCC
IGND
PSRR
From AVCC
From AGND
From AVCC
0.6
80
2.2
mA
mA
dB
Note 4. Average input impedance is calculated as an average of the impedance measured for all gain values.
Note 5. Output offset voltage depends on external opamp and selected gain. Low input offset voltage and input bias current opamp is
recommended to be used for minimum output offset.
9 (18)
MAS [ MICRO ANALOG SYSTEMS ]
