Electrical Specifications
Table 57: SATA II Interface Gen2m Mode Driver and Receiver Characteristics
Description
Symbol
BR
Min
Max
Units
Gbps
ppm
kHz
Notes
Baud Rate
3.0
-
-
-
-
-
Baud rate tolerance
Bppm
Fssc
SSCtol
UI
-350.0
30.0
350.0
33.0
0.0
Spread spectrum modulation frequency
Spread spectrum modulation Deviation
Unit Interval
-5000.0
ppm
ps
333.33
Driver Parameters
Output differential voltage
Vdifftx
RLOD
RLOD
RLOD
RLOD
TJ10
400.0
700.0
mV
dB
dB
dB
dB
UI
1 , 2
Differential return loss (150 MHz-300 MHz)
Differential return loss (300 MHz-600 MHz)
Differential return loss (600 MHz-2.4 GHz)
Differential return loss (2.4 GHz-3.0 GHz)
Total jitter at connector clock-data
14.0
-
-
-
8.0
-
6.0
-
-
3.0
-
-
-
-
-
-
0.30
0.17
0.37
0.19
3
3
4
4
Deterministic jitter at connector clock-data
Total jitter at connector clock-data
DJ10
UI
TJ500
DJ500
UI
Deterministic jitter at connector clock-data
UI
Receiver Parameters
Input differential voltage
Vdiffrx
RLID
240.0
18.0
14.0
10.0
8.0
3.0
-
750.0
mV
dB
dB
dB
dB
dB
UI
5
-
Differential return loss (150 MHz-300 MHz)
Differential return loss (300 MHz-600 MHz)
Differential return loss (600 MHz-1.2 GHz)
Differential return loss (1.2 GHz-2.4 GHz)
Differential return loss (2.4 GHz-3.0 GHz)
Total jitter at connector clock-data
-
RLID
-
-
RLID
-
-
RLID
-
-
RLID
-
-
TJ10
DJ10
TJ500
DJ500
0.46
0.35
0.60
0.42
3
3
4
4
Deterministic jitter at connector clock-data
Total jitter at connector clock-data
-
UI
-
UI
Deterministic jitter at connector clock-data
-
UI
Notes :
General Comment: For more information, refer to SATA II Revision 2.6 Specification, February, 2007.
General Comment: The load is 100 ohm differential for these parameters, unless otherw ise specified.
General Comment: To comply w ith the values presented in this table, refer to your local
Marvell representative for register settings.
1. 0.45-0.55 UI is the range w here the signal meets the minimum level.
2. Output Differential Amplitude and Pre-Emphasis are configurabile. See functional register description
for more details.
3. Defined for BR/10.
4. Defined for BR/500.
5. 0.5 UI is the point w here the signal meets the minimum level.
Copyright © 2008 Marvell
MV-S104552-U0 Rev. D
Page 111
December 6, 2008, Preliminary
Document Classification: Proprietary Information