Data Sheet
FNW500R Power Modules; DC-DC Converters
36 – 75 Vdc Input; 28Vdc Output; 500W Output
September 8, 2008
Feature Description (continued)
With an external resistor between the TRIM and
SENSE(-) pins (Radj-down), the output voltage set
point (Vo,adj) decreases (see Figure 11). The following
equation determines the required external-resistor
value to obtain a percentage output voltage change of
Δ%.
For output voltages: 28V
100
⎛
⎜
⎞
⎠
Radj − down = 5.97×
−1 KΩ
⎟
Δ%
⎝
Figure 12. Circuit Configuration to Increase Output
Voltage.
Where,
The voltage between the Vo(+) and Vo(-) terminals
must not exceed the minimum output overvoltage shut-
down value indicated in the Feature Specifications
table. This limit includes any increase in voltage due to
remote- sense compensation and output voltage set-
point adjustment (trim). See Figure 13.
V
o, nom −Vdesired
Δ% =
×100
Vo, nom
V
desired = Desired output voltage set point (V).
Although the output voltage can be increased by both
the remote sense and by the trim, the maximum
increase for the output voltage is not the sum of both.
The maximum increase is the larger of either the
remote sense or the trim.
The amount of power delivered by the module is
defined as the voltage at the output terminals multiplied
by the output current. When using remote sense and
trim, the output voltage of the module can be
increased, which the same output current would
increase the power output of the module. Care should
be taken to ensure that the maximum output power of
the module remains at or below the maximum rated
power.
F
Figure 11. Circuit Configuration to Decrease Output
Voltage.
Examples:
To trim down the output of a nominal 28V module to
16.8V
Trim Up – Increase Output Voltage
28V −16.8V
Δ% =
×100
With an external resistor connected between the Vo(+)
and SENSE(+) pins (Radj-up), the output voltage set
point (Vo,adj) increases (see Figure 12).
28V
∆% = 40
The following equation determines the required
external-resistor value to obtain a percentage output
voltage change of Δ%.
100
40
⎛
⎜
⎞
⎠
R
adj − down = 5.97×
−1 KΩ
⎟
⎝
For output voltages: 28V
Radj-down = 8.96 kΩ
Vo, nom× Δ%
To trim up the output of a nominal 28V module to 30.8V
R
adj − up
=
KΩ
100
30.8V − 28V
Δ% =
×100
Where,
28V
V
desired −Vo, nom
Δ% = 10
Δ% =
×100
Vo, nom
28×10
100
Radj −up =
KΩ
Vdesired = Desired output voltage set point (V).
Rtadj-up = 2.8 KΩ
LINEAGE POWER
8
LINEAGEPOWER [ LINEAGE POWER CORPORATION ]
