11 | Keysight | M9195A PXIe Digital Stimulus/Response with PMU: 250 MHz, 16-channel - Data Sheet
Definitions for specifications and characteristics
Specifications
Warranted performance. Specifications include guardbands to account for the expected statistical performance distribution,
measurement uncertainties, and changes in performance due to environmental conditions. All specifications and characteris-
tics apply over the operating environment outlined in “Environmental and Regulatory” section of this data sheet. In addition, the
following conditions must be met:
– Instrument has been turned on for 30 minutes with the PXI DSR software running.
– Instrument is within its calibration cycle.
– Instrument remains at a stable surrounding environment temperature (between 0°C to 45°C) for 1 hour prior to turn-on.
Specifications in this document are identified by an asterisk (*).
Characteristics
Typical
A performance parameter that the product is expected to meet before it leaves the factory. A characteristic includes the same
guardbands as a specification.
Expected performance of an average unit at a stable temperature between 20°C to 30°C for 30 minutes prior to turn-on and
during operation; does not include guardbands. The instrument must be within its calibration cycle.
Nominal
A general, descriptive term or design parameter. It is not tested. Data represented in this document are nominal unless other-
wise identified.
Best practices
To ensure proper cooling, use Keysight slot blockers (Y1212A), filler panels (Y1213A), and the air inlet module kit (Y1214A) in
the chassis when there are empty slots. Keysight chassis and filler panels optimize module temperature performance.
At environmental temperatures > 40 °C, chassis fans should be set to high.
Additional information
All data are measured from multiple units at room temperature and are representative of product performance within the oper-
ating temperature range unless otherwise noted.
The specifications contained in this document are subject to change.
Technical specifications and characteristics
General Characteristics
Module characteristics
Bus interface & compatibility
Number of data channels
PXI Express peripheral module (x1, x4, x8 PCIe® specification v 2.1)
16, per-channel parametric measurement unit (PPMU)
Number of sites per module
Maximum data rate for data channels
Maximum RTZ clock on data channels
Number of high voltage channels
Number of auxiliary open drain channels
Number of GPIO channels
One 16 channel or four 4-channel sites
250 Mbps
250 MHz
4
4
2 1
Module memory
2 GB (allocated between pattern, response capture and sequence control)
Front panel connectors
Data , open drain, HV, PPMU sense
Reference clock input (REF CLK IN)
Sync in/out (SYNC)
ERCD30
SMB connector
SMB connector 1
SMB connector 1
GPIO 1 and GPIO 2
Mechanical characteristics
Dimensions
3U/1-slot PXIe standard
(H x W x D) in mm
130.1 x 21.7 x 210 mm; includes connector and handle extensions
Weight
482 g
1. Reserved for future use.
KEYSIGHT [ Keysight Technologies ]
