21 | Keysight | InfiniiVision 1000 X-Series Oscilloscopes - Data Sheet
Performance Characteristics (Continued)
Trigger type selections
EDUX1002A/EDUX1002G
DSOX1102A/DSOX1102G
Trigger types
Edge, pulse width, video, pattern/state
Edge, pulse width, video, rise/fall time, setup and
hold, pattern/state
Edge
Pattern/state
Pulse width
Trigger on a rising, falling, alternating or either edge of any source
Trigger when a specified pattern/state on any combination inputs is entered 8
Trigger on a pulse of a selected channel with a
time duration that is ‘less than a value,’ ‘greater
than a value’ or ‘inside a time range’
Range minimum: 10 ns, 10 s max
Not available
Trigger on a pulse of a selected channel with a
time duration that is ‘less than a value,’ ‘greater
than a value’ or ‘inside a time range’
Range minimum: 10 ns, 10 s max
Trigger and clock/data setup and/or hold time
violation. Setup time can be set from –7 ns to
10 s. Hold time can be set from 0 s to 10 ns
Trigger on rise-time or fall-time edge speed
violations (< or >) based on user-selectable
threshold
Setup and hold
Rise/fall time
Not available
Select from (< or >) and time settings range
between
Minimum: 5 ns
Maximum: 10 s
Video
Trigger on all lines or individual lines; odd/even or all fields from composite video; or broadcast
standards (NTSC, PAL, SECAM and PAM-M)
Trigger at a start/stop condition or user-defined frame with address and/or data values. Also trigger
on missing acknowledge, restart, EEPROM read and 10-bit write
I2C
– EDUX1EMBD option
– DSOX1EMBD option
RS-232/422/485/UART
– EDUX1EMBD option
– DSOX1EMBD option
SPI
Trigger on Rx or Tx start bit, stop bit, data content or parity error
Not available
Not available
Trigger on SPI (Serial Peripheral Interface)
data pattern during a specific framing period.
Supports positive and negative chip select
framing as well as clock idle framing and user-
specified number of bits per frame. Supports
MOSI or MISO data as half duplex data
Trigger on CAN (controller area network) version
2.0A or 2.0B signals. Trigger on the start of
frame (SOF), end of frame (EOF), data frame ID,
data frame ID and data (non-FD), data frame ID
and data (FD), remote frame ID, remote or data
frame ID, error frame, acknowledge error, from
error, stuff error, CRC error, spec error (ack or
form or stuff or CRC), all errors, BRS bit (FD),
CRC delimiter bit (FD), ESI bit active (FD), ESI bit
passive (FD), overload frame, message, message
and signal (non-FD), message and signal (FD, first
8 bytes only)
– DSOX1EMBD option
CAN
– DSOX1AUTO option
LIN
Not available
Trigger on LIN (Local Interconnect Network) sync
break, sync frame ID or frame ID and data, parity
error, checksum error and frame
– DSOX1AUTO option
8� Pattern must have stabilized for a minimum of 5 ns to qualify as a valid trigger condition�
KEYSIGHT [ Keysight Technologies ]
