CAB IP69K
Recommended Method of Mounting
General Information
Connector shell is fixed with 4 screws on the housing. In combination
with universal endbell and an o-ring between flange receptacle and
wall the connector will reach IP68 sealing (1 bar, 16h) and IP69K
sealing acc. to ISO20653.
Scope
This specification describes a CA-B connector with a sealing
effectiveness up to IP69K. This connector is interchangeable with
the corresponding types as per MIL-C-5015 and VG95234, as they
offer the same mounting dimensions and contact arrangements.
These connectors are without spring washer, friction ring and
grommet.
Ratings & Characteristics
Locking Device
Bayonet Coupling
Contact Type
Crimp or Solder Contacts
Electrical Characteristics
Environmental Characteristics
In accordance with VG95234 bayonet coupling
In accordance with VG95234 bayonet coupling
Deviance with plating A240: 500h salt spray test with mated pair
Deviance with plating A34: 48h salt spray test
Water tightness for mated connector
IP68 (1bar, 16h) and IP69K in combination with universal endbell and o-ring
(flange receptacle to wall)
Normative references
DIN EN 61984
IEC 60068
Electrical Connector, safety requirements and tests
Environmental tests
IEC 60352
Crimp connection and requirements
IEC 60512
Electrical Connector, measuring and test procedure
Specification for degrees of protection provided by enclosures
Electromagnetic compatibility
IEC 60529
VG 95373
Mechanical Characteristics
Designation
Shell
Material
Finish
Coupling Nut
Endbell
Aluminium-alloy
According to order reference
Cone Ring
Clamping Nut
Clutch Spring
Circlip
Spring Steel
Copper-alloy
PPS
-
Contact
Silver Plated and Passivated
-
Clutch Ring
Shielding Sleeve
Clamping Ring
Insulator
PA66
PBT
Sealing Ring
Grommet
CR-rubber
-
O-ring
Dimensions shown in mm
Specifications and dimensions subject to change
www.ittcannon.com
43
ITT [ ITT Cannon ]
