80C186EC/188EC, 80L186EC/188EC
DC SPECIFICATIONS (80L186EC13/80L188EC13)
Symbol
Parameter
Supply Voltage
Min
Max
Units
V
Notes
V
V
V
V
V
V
2.7
5.5
CC
IL
b
Input Low Voltage
0.5
0.7 V
0.3 V
V
CC
a
V
CC
Input High Voltage
0.5
V
IH
CC
e
Output Low Voltage
Output High Voltage
Input Hysteresis on RESIN
0.45
V
I
I
3 mA (Min)
OL
OH
HYR
OL
b
e b
2 mA (Min)
V
0.5
V
CC
OH
0.5
V
s
s
V
g
I
Input Leakage Current for Pins:
AD15:0 (AD7:0, A15:8), READY,
HOLD, RESIN, CLKIN,
15
mA
0
V
LI
IN
CC
TEST/BUSY, NMI, INT7:0,
T0IN, T1IN, P2.7–P2.0, P3.5–P3.0,
DRQ3:0, PEREQ, ERROR
b
b
e
0.7 V
IN
(Note 1)
I
Input Leakage for Pins with Pullups
Active During Reset:
A19:16, LOCK
0.275
5
mA
V
LIU
CC
s
s
V
g
I
I
I
I
Output Leakage for Floated Output
Pins
15
mA
0.45
(Note 2)
V
LO
CC
ID
OUT
CC
Supply Current Cold (in RESET)
80L186EC-13
(Note 3)
(Note 4)
(Note 5)
36
mA
mA
Supply Current in Idle Mode
80L186EC-13
24
Supply Current in Powerdown Mode
80L186EC-13
PD
30
15
15
mA
pF
pF
e
e
C
C
Input Pin Capacitance
Output Pin Capacitance
0
0
T
T
1 MHz
1 MHz (Note 6)
IN
F
F
OUT
NOTES:
1. These pins have an internal pull-up device that is active while RESIN is low and ONCE Mode is not active. Sourcing more
current than specified (on any of these pins) may invoke a factory test mode.
2. Tested by outputs being floated by invoking ONCE Mode or by asserting HOLD.
3. Measured with the device in RESET and at worst case frequency, V , and temperature with ALL outputs loaded as
CC
or GND.
specified in AC Test Conditions, and all floating outputs driven to V
4. Measured with the device in HALT (IDLE Mode active) and at worst case frequency, V , and temperature with ALL
CC
CC
or GND.
5. Measured with the device in HALT (Powerdown Mode active) and at worst case frequency, V , and temperature with
outputs loaded as specified in AC Test Conditions, and all floating outputs driven to V
CC
CC
or GND.
ALL outputs loaded as specified in AC Test Conditions, and all floating outputs driven to V
6. Output Capacitance is the capacitive load of a floating output pin.
CC
27