Electrical Characteristics
length at the package pin boundary. If the vendor does not explicitly state where the measurement
point is located, the measurement point is assumed to be the D+ and D-package pins.
Figure 4-2. Compliance Test/Measurement Load
The test load is shown at the transmitter package reference plane, but the same Test/Measurement
load is applicable to the receiver package reference plane. CTX is an optional portion of the
measurement test load. The measurement should be taken on the opposite side of the capacitor
from the package, and the value of the CTX must be in the range of 75 nF to 200 nF.
Figure 4-3. Minimum Receiver Eye Timing and Voltage Compliance Specification
The RX eye diagram must be aligned in time using the jitter median to locate the center of the eye
diagram.
Intel® 6702PXH 64-bit PCI Hub Datasheet
163