Pin Listing and Signal Descriptions
Table 4-3. Signal Description (Sheet 3 of 8)
Name
Type
Description
D[63:0]# (Data) are the data signals. These signals provide a 64-bit data path
between the processor FSB agents, and must connect the appropriate pins on
all such agents. The data driver asserts DRDY# to indicate a valid data transfer.
D[63:0]# are quad-pumped signals and will thus be driven four times in a
common clock period. D[63:0]# are latched off the falling edge of both
DSTBP[3:0]# and DSTBN[3:0]#. Each group of 16 data signals correspond to a
pair of one DSTBP# and one DSTBN#. The following table shows the grouping
of data signals to data strobes and DBI#.
Quad-Pumped Signal Groups
DSTBN#/
DSTBP#
Input/
Output
Data Group
DBI#
D[63:0]#
D[15:0]#
D[31:16]#
D[47:32]#
D[63:48]#
0
1
2
3
0
1
2
3
Furthermore, the DBI# pins determine the polarity of the data signals. Each
group of 16 data signals corresponds to one DBI# signal. When the DBI# signal
is active, the corresponding data group is inverted and therefore sampled active
high.
DBI[3:0]# (Data Bus Invert) are source synchronous and indicate the polarity of
the D[63:0]# signals.The DBI[3:0]# signals are activated when the data on the
data bus is inverted. If more than half the data bits, within a 16-bit group, would
have been asserted electrically low, the bus agent may invert the data bus
signals for that particular sub-phase for that 16-bit group.
DBI[3:0] Assignment To Data Bus
Input/
Output
DBI[3:0]#
Bus Signal
Data Bus Signals
DBI3#
DBI2#
DBI1#
DBI0#
D[63:48]#
D[47:32]#
D[31:16]#
D[15:0]#
DBR# (Debug Reset) is used only in processor systems where no debug port is
implemented on the system board. DBR# is used by a debug port interposer so
that an in-target probe can drive system reset. If a debug port is implemented in
the system, DBR# is a no connect in the system. DBR# is not a processor signal.
DBR#
Output
DBSY# (Data Bus Busy) is asserted by the agent responsible for driving data on
Input/ the processor FSB to indicate that the data bus is in use. The data bus is
Output released after DBSY# is de-asserted. This signal must connect the appropriate
pins on all processor FSB agents.
DBSY#
DEFER# is asserted by an agent to indicate that a transaction cannot be
guaranteed in-order completion. Assertion of DEFER# is normally the
responsibility of the addressed memory or Input/Output agent. This signal must
connect the appropriate pins of all processor FSB agents.
DEFER#
DP[3:0]#
Input
DP[3:0]# (Data Parity) provide parity protection for the D[63:0]# signals. They
are driven by the agent responsible for driving D[63:0]#, and must connect the
appropriate pins of all Celeron D processor FSB agents.
Input/
Output
56
Datasheet
INTEL [ INTEL ]
