A10-DATASHEET
2015.12.31
105
Document Revision History
Date
Version
Changes
•
Updated the AS Timing Parameters for AS ×1 and AS ×4 Configurations in Arria 10 Devices table as
follows:
•
•
•
Changed the symbol for data hold time from tH to tDH
Updated the minimum value for tSU from 0 ns to 1 ns.
Updated the minimum value for tDH from 2.5 ns to 1.5 ns.
.
•
•
Added a note to the DCLK Frequency Specification in the AS Configuration Scheme table. Note: You can
only set 12.5, 25, 50, and 100 MHz in the Quartus Prime software.
Added a note to the Initialization Clock Source Option and the Maximum Frequency for Arria 10 Devices.
Note: If you use the CLKUSRpin for AS and transceiver calibration simultaneously, the only allowed
frequency is 100 MHz.
•
Changed Arria 10 GS to Arria 10 SX in Uncompressed .rbf Sizes and Minimum Configuration Time
Estimation tables.
•
•
Added IO_IN_DLY_CHN and IO_OUT_DLY_CHN in the IOE Programmable Delay table.
Changed the Min/Typ/Max description for the VICM (AC coupled) parameter in the "Reference Clock
Specifications" table.
•
•
•
•
Changed the Min/Typ/Max values in the "Transceiver Power Supply Operating Conditions for Arria 10 GX/
SX Devices" table.
Changed the Min/Typ/Max values in the "Transceiver Power Supply Operating Conditions for Arria 10 GT
Devices" table.
Added a footnote to the maximum data rate for GT channels in the "Transceiver Performance for GT
Devices" section.
Made the following changes to the "Transceiver Performance for Arria 10 GX/SX Devices" section.
•
Changed the maximum data rate condition for chip-to-chip and backplane in the "Transmitter and
Receiver Data Rate Performance" table.
•
•
•
•
Added TX minimum data rate to the "Transmitter and Receiver Data Rate Performance" table.
Changed the minimum frequency in the "ATX PLL Performance" table.
Changed the minimum frequency in the "Fractional PLL Performance" table.
Changed the minimum and maximum frequency in the "CMU PLL Performance" table.
Arria 10 Device Datasheet
Send Feedback
Altera Corporation