Page 22 of 32
IA80C152
Preliminary Data Sheet
UNIVERSAL COMMUNICATIONS CONTROLLER
Absolute Maximum Ratings
AC/DC Parameters
Ambient temperature under bias....................................-40°C to +85°C (2)
Operating temperature…………………………..…-40°C to +85°C
Storage temperature..................................…...................-65°C to +150°C
Voltage on any pin to VSS.............................................-0.3 to (VDD +0.3)
Power dissipation.................................................…........391.1 mW (95°C, 16MHz, 15% Toggle)
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. Operating the
device beyond the conditions indicated in the “recommended operating conditions” section is not recommended. Operation
at the “absolute maximum ratings” may adversely affect device reliability.
Notes: Design, Static and Dynamic Timing Characterization in Progress.
Table 8: DC Characteristics
Symbol
VIL
Parameter
Input Low Voltage
(All Except EAn, EBEN)
Input Low Voltage
(EAn, EBEN)
Input High Voltage
( Except XTAL1, RSTn)
Input High Voltage
( XTAL1 RSTn)
Output Low Voltage
(Ports 1, 2, 3, 4, 5, 6)
Min
Typ
Max
Unit
V
Test Conditions
VIL1
VIH
V
V
VIH1
VOL
VOL1
V
V
Output Low Voltage
(Ports 0, ALE.PSENn, EPSENn)
V
VOH
Output High Voltage
V
V
(Ports 1, 2, 3, 4, 5, 6, COMM9
ALE, PSENn, EPSENn)
VOH1
Output High Voltage
(Port 0 in External
Bus Mode)
V
V
IIL
Logical 0 Input Current
(Ports 1, 2, 3, 4, 5, 6)
Logical 1 to 0
µA
ITL
Transition Current
(Ports 1, 2, 3, 4, 5, 6)
Input Leakage
µA
µA
ILI
( Port 0, EAn)
RRST
IIH
Reset Pull-up Resistor
k
W
Logical 1 Input Current (EBEN)
Power Supply Current:
Active (16.5 MHz)
Idle(16.5 MHz)
Power Down Mode
µA
IDD
mA
mA
µA
100
(1)
Notes:
(1) Static Idd current is exclusive of input/output drive requirements and is measured with the clocks stopped and all inputs
tied to Vdd or Vss, configured to draw minimum current.
(2) The input and output parametric values in section VII-B, parts 1, 2, and 3, are directly related to ambient temperature and
DC supply voltage. A temperature or supply voltage range other than those specified in the Operating Conditions above will
affect these values and part performance is not guaranteed by innovASIC.
Copyright ã 2000
innovASIC
[_________The End of Obsolescenceä