欢迎访问ic37.com |
会员登录 免费注册
发布采购

TLE6225G 参数 Datasheet PDF下载

TLE6225G图片预览
型号: TLE6225G
PDF下载: 下载PDF文件 查看货源
内容描述: 智能四核低边开关 [Smart Quad Low-Side Switch]
分类和应用: 外围驱动器驱动程序和接口开关接口集成电路光电二极管
文件页数/大小: 9 页 / 240 K
品牌: INFINEON [ Infineon ]
 浏览型号TLE6225G的Datasheet PDF文件第1页浏览型号TLE6225G的Datasheet PDF文件第2页浏览型号TLE6225G的Datasheet PDF文件第3页浏览型号TLE6225G的Datasheet PDF文件第4页浏览型号TLE6225G的Datasheet PDF文件第6页浏览型号TLE6225G的Datasheet PDF文件第7页浏览型号TLE6225G的Datasheet PDF文件第8页浏览型号TLE6225G的Datasheet PDF文件第9页  
Data Sheet TLE 6225 G  
Functional Description  
The TLE 6225 G is a quad channel low-side switch with four power DMOS stages. The power  
transistors are protected against short to VBB, overload, overtemperature and against over-  
voltage by zenerclamp.  
The diagnostic logic recognises a fault condition which is indicated by a fault flag.  
Circuit Description  
Output Stage Control  
Each output is independently controlled by an input pin and a common enable line, which en-  
ables/disables all four outputs. The parallel inputs are high or low active depending on the  
PRG pin. If the parallel input pins are not connected (independent of high or low activity) it is  
guaranteed that the outputs 1 to 4 are switched OFF. ENA - and PRG - pin itself are internally  
pulled down when they are not connected.  
ENA - Enable pin.  
PRG - Program pin.  
Power Transistors  
ENA = High:  
Active mode. Channels are enabled  
ENA = Low (GND): Sleep mode. Channels are switched off. Less than  
1 µA current consumption.  
PRG = High:  
Parallel inputs Channel 1 to 4 are high active  
PRG = Low (GND): Parallel inputs Channel 1 to 4 are low active.  
Each of the four output stages has its own zenerclamp. This causes a voltage limitation at the  
power transistors when inductive loads are switched off. The outputs are provided with a cur-  
rent limitation set to a minimum of 500 mA.  
Each output is protected by embedded protection functions3). In the event of an overload or  
short to supply, the current is internally limited. If this operation leads to an overtemperature  
condition, a second protection level (about 170 °C) will turn the effected output into a PWM-  
mode (selective thermal shutdown with restart) to prevent critical chip temperatures. The tem-  
perature hysteresis is typically 10K.  
Diagnostic  
The FAULT pin is an open drain output. The logic status depends on the programming pin  
PRG.  
FAULT - pin.  
FAULT = High  
FAULT = Low  
no fault @ PRG = High  
no fault @ PRG = Low  
3) The integrated protection functions prevent an IC destruction under fault conditions and may not be used in normal operation or perma-  
nently  
V2.1  
Page  
26.Aug. 2002  
5
 复制成功!