HITFET - BTS3080TF
Smart Low-Side Power Switch
Electrical Characteristics
Table 5
Electrical Characteristics: Power Stage (cont’d)
Tj = -40°C to +150°C, VBAT = 6 V to 18 V, all voltages with respect to ground, positive current flowing into pin
(unless otherwise specified)
Parameter
Symbol
Values
Unit Note or
Test Condition
Number
Min. Typ. Max.
Dynamic characteristics - switching times single pulseVBAT = 13.5 V, RL = 4.7Ω;
for definition details see Figure 10 “Definition of Power Output Timing for Resistive Load” on Page 11
3)
Turn-on time
tON
35
75
115 µs
P_8.1.46
VIN = 0 V to 5 V;
VOUT = 10% VBAT
4)
Turn-off time
tOFF
70
135 210 µs
P_8.1.47
VIN = 5 V to 0 V;
VOUT = 90% VBAT
Turn-on delay time
Turn-off delay time
tDON
5
15
75
60
25
µs
VIN = 0 V to 5 V;
VOUT = 90% VBAT
P_8.1.48
P_8.1.49
P_8.1.50
tDOFF
40
30
120 µs
VIN = 5 V to 0 V;
VOUT = 10% VBAT
Fall time, Falling output voltage (turn- tF
on)
90
90
µs
µs
VIN = 0 V to 5 V;
VOUT = 90% VBAT to
V
OUT = 10% VBAT
Rise time, Rising output voltage
Turn-on Slew rate
tR
30
60
VIN = 5 V to 0 V;
P_8.1.51
P_8.1.52
P_8.1.53
V
V
OUT = 10% VBAT to
OUT = 90% VBAT
5)
-(ΔV/Δt)ON 0.22 0.45 0.65 V/µs
(ΔV/Δt)OFF 0.22 0.45 0.65 V/µs
VOUT = 90% VBAT to
VOUT = 50% VBAT
6)
Turn-off Slew rate
VOUT = 50% VBAT to
V
OUT = 90% VBAT
1) Not subject to production test, calculated by RthJA (JEDEC 2s2p, PCB) and RDS(ON)
2) Not subject to production test, specified by design;
3) Not subject to production test, calculated with delay time ON and fall time
4) Not subject to production test, calculated with delay time OFF and rise time
5) Not subject to production test, calculated slew rate between 90% and 50% VOUT
6) Not subject to production test, calculated slew rate between 50% and 90% VOUT
;
;
8.2
Protection
Please see Chapter “Protection Functions” on Page 15 for parameter description and further details.
Note:
Integrated protection functions are designed to prevent IC destruction under fault conditions
described in the data sheet. Fault conditions are considered as “outside” normal operating range.
Protection functions are not designed for continuous repetitive operation
Datasheet
19
Rev. 1.0
2016-06-01