ICS1893BY-10 Data Sheet - Release
Chapter 8 Pin Diagram, Listings, and Descriptions
Table 8-3. PHY Address and LED Pins
Pin
Pin
Pin
Pin Description
Name Number
Type
P1CL 59
Input or PHY (Address Bit) 1 / Collision LED.
Output For more information on this pin, see Section 5.5, “Twisted-Pair Interface”.
• This multi-function configuration pin is:
– An input pin during either a power-on reset or a hardware reset. In
this case, this pin configures the ICS1893BY-10 when it is in either
hardware mode or software mode.
– An output pin following reset. In this case, this pin provides collision
status for the ICS1893BY-10.
As an input pin:
• This pin establishes the address for the ICS1893BY-10. When the
signal on this pin is logic:
– Low, that address bit is set to logic zero.
– High, that address bit is set to logic one.
As an output pin:
• When the signal on this pin is:
– De-asserted, this state indicates the ICS1893BY-10 does not detect
any collisions.
– Asserted, this state indicates the ICS1893BY-10 detects collisions.
• The ICS1893BY-10 asserts its Collision LED for a period of
approximately 70 msec when it detects a collision.
Caution: This pin must not float. (See the notes at Section 8.3.2,
“Multi-Function (Multiplexed) Pins: PHY Address and LED
Pins”.)
P2LI
60
Input or PHY (Address Bit) 2 / Link Integrity LED.
Output For more information on this pin, see Section 5.8, “Status Interface”.
• This multi-function configuration pin is:
– An input pin during either a power-on reset or a hardware reset. In
this case, this pin configures the address of the ICS1893BY-10 when
it is in either hardware mode or software mode.
– An output pin following reset. In this case, this pin provides link status
for the ICS1893BY-10.
As an input pin:
• This pins establishes the address for the ICS1893BY-10. When the
signal on this pin is logic:
– Low, that address bit is set to logic zero.
– High, that address bit is set to logic one.
As an output pin:
• When the signal on this pin is:
– De-asserted, this state indicates the ICS1893BY-10 does not have a
link.
– Asserted, this state indicates the ICS1893BY-10 has a valid link.
Caution: This pin must not float. (See the notes at Section 8.3.2,
“Multi-Function (Multiplexed) Pins: PHY Address and LED
Pins”.)
ICS1893BY-10 Rev A 3/24/04
March, 2004
Copyright © 2004, Integrated Circuit Systems, Inc.
All rights reserved.
102