iC-ML
HALL Position Sensor / Encoder
Rev A3, Page 16/17
DATA INPUT
the value of the DIR signal. A low at DIR triggers a
countup; a high causes the setup to count down. Fig-
ure 17 shows a countup sequence followed by a count-
down sequence, both across the zero position.
VDD
P0 P1 P2 P3
CPU
P0 P1 P2 P3
CPU
CFG1
CFG2
CFG3
NEN
NCLUP
NCLDN
TCU
TCD
MR
TCU
TCD
MR
CPD
NPL
CPD
NPL
74HCT193
74HCT193
iC-ML
NCLR
Q0 Q1 Q2 Q3
Q0 Q1 Q2 Q3
NERR
RESET
GND
CLK
OUTPUT
Figure 20: iC-ML with binary counter 74HCT193
DIR
DIR-INC mode
In DIR-INC mode a change in angle for both directions
of rotation generates an output pulse for signal CLK
(pin A). Signal DIR (pin B) gives the direction of ro-
tation. This mode permits the operation of external
binary counter modules (such as 74HC/HCT191, for
example), with signal NCLR (pin C) being used to re-
set the external counter. With a rising edge at CLK the
counter status is counted up or down, depending on
NCLR
Time [us]
Figure 21: DIR-INC mode
iC-Haus expressly reserves the right to change its products and/or specifications. An Infoletter gives details as to any amendments and additions made to the
relevant current specifications on our internet website www.ichaus.de/infoletter; this letter is generated automatically and shall be sent to registered users by
email.
Copying – even as an excerpt – is only permitted with iC-Haus approval in writing and precise reference to source.
iC-Haus does not warrant the accuracy, completeness or timeliness of the specification on this site and does not assume liability for any errors or omissions
in the materials. The data specified is intended solely for the purpose of product description. No representations or warranties, either express or implied, of
merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to information/specification or the products to which
information refers and no guarantee with respect to compliance to the intended use is given. In particular, this also applies to the stated possible applications or
areas of applications of the product.
iC-Haus conveys no patent, copyright, mask work right or other trade mark right to this product. iC-Haus assumes no liability for any patent and/or other trade
mark rights of a third party resulting from processing or handling of the product and/or any other use of the product.
As a general rule our developments, IPs, principle circuitry and range of Integrated Circuits are suitable and specifically designed for appropriate use in technical
applications, such as in devices, systems and any kind of technical equipment, in so far as they do not infringe existing patent rights. In principle the range of
use is limitless in a technical sense and refers to the products listed in the inventory of goods compiled for the 2008 and following export trade statistics issued
annually by the Bureau of Statistics in Wiesbaden, for example, or to any product in the product catalogue published for the 2007 and following exhibitions in
Hanover (Hannover-Messe).
We understand suitable application of our published designs to be state-of-the-art technology which can no longer be classed as inventive under the stipulations
of patent law. Our explicit application notes are to be treated only as mere examples of the many possible and extremely advantageous uses our products can
be put to.