PowerPC 405GP Embedded Processor Data Sheet
Signal Functional Description (Part 5 of 8)
Multiplexed signals are shown in brackets following the first signal name assigned to each multiplexed ball.
Notes:
1. Receiver input has hysteresis.
2. Must pull up. See “Pull-Up and Pull-Down Resistors” on page 33 for recommended termination values.
3. Must pull down. See “Pull-Up and Pull-Down Resistors” on page 33 for recommended termination values.
4. If not used, must pull up.
5. If not used, must pull down.
6. Strapping input during reset; pull up or pull down as required.
7. Pull-up may be required. See “External Bus Control Signals” on page 33.
Signal Name
Description
I/O
Type
Notes
External Master Peripheral Interface
Peripheral clock to be used by an external master and by
synchronous peripheral slaves.
5V tolerant
3.3V LVTTL
PerClk
ExtReset
HoldReq
HoldAck
ExtReq
ExtAck
O
O
I
Peripheral reset to be used by an external master and by
synchronous peripheral slaves.
5V tolerant
3.3V LVTTL
Hold Request, used by an external master to request ownership
of the peripheral bus.
5V tolerant
3.3V LVTTL
1, 5
6
Hold Acknowledge, used by the PPC405GP to transfer ownership
of peripheral bus to an external master.
5V tolerant
3.3V LVTTL
O
I
ExtReq is used by an external master to indicate it is prepared to
transfer data.
5V tolerant
3.3V LVTTL
1
ExtAck is used by the PPC405GP to indicate a data transfer
cycle.
5V tolerant
3.3V LVTTL
O
I
6
Used by an external master to indicate the priority of a given
external master tenure.
5V tolerant
3.3V LVTTL
HoldPri
BusReq
PerErr
1
Used when the PPC405GP needs to regain control of peripheral
interface from an external master.
5V tolerant
3.3V LVTTL
O
I
An input used to indicate to the PPC405GP that an external slave
peripheral error occurred.
5V tolerant
3.3V LVTTL
1, 5
Internal Peripheral Interface
Serial Clock used to provide an alternate clock to the internally
generated serial clock. Used in cases where the allowable
internally generated baud rates are not satisfactory. This input
can be individually connected to either UART.
5V tolerant
3.3V LVTTL
UARTSerClk
I
1
5V tolerant
3.3V LVTTL
UART0_Rx
UART0_Tx
UART0 Serial Data In.
I
O
I
1
6
1
1
1
6
6
1
5V tolerant
3.3V LVTTL
UART0 Serial Data Out.
UART0 Data Carrier Detect.
UART0 Data Set Ready.
UART0 Clear To Send.
UART0 Data Terminal Ready.
UART0 Request To Send.
UART0 Ring Indicator.
5V tolerant
3.3V LVTTL
UART0_DCD
UART0_DSR
UART0_CTS
UART0_DTR
UART0_RTS
UART0_RI
5V tolerant
3.3V LVTTL
I
5V tolerant
3.3V LVTTL
I
5V tolerant
3.3V LVTTL
O
O
I
5V tolerant
3.3V LVTTL
5V tolerant
3.3V LVTTL
Page 38 of 60
6/20/03