RFM23
detection.
The Invalid Preamble Detector issues an interrupt when no valid preamble signal is found. After the receiver is enabled, the
Invalid Preamble Detector output is ignored for 16 Tb (Where Tb is the time of a bit duration) to allow the receiver to settle.
The Invalid Preamble Detect interrupt can be used to save power and speed-up search in receive mode. It is advised to
mask the invalid preamble interrupt when Antenna Diversity is enabled.
The Received Signal Strength Indicator (RSSI) provides a measure of the signal strength received on the tuned channel.
The resolution of the RSSI is 0.5 dB. This high resolution RSSI enables accurate channel power measurements for clear
channel assessment (CCA), carrier sense (CS), and listen before talk (LBT) functionality.
Frequency mistuning caused by crystal inaccuracies can be compensated by enabling the digital Automatic Frequency
Control (AFC) in receive mode.
A comprehensive programmable Packet Handler including key features of EZMacTM is integrated to create a variety of
communication topologies ranging from peer-to-peer networks to mesh networks. The extensive programmability of the
packet header allows for advanced packet filtering which in turn enables a mix of broadcast, group, and point-to-point
communication.
A wireless communication channel can be corrupted by noise and interference, and it is therefore important to know if the
received data is free of errors. A cyclic redundancy check (CRC) is used to detect the presence of erroneous bits in each
packet. A CRC is computed and appended at the tail of each transmitted packet and verified by the receiver to confirm that
no errors have occurred. The Packet Handler and CRC are extremely valuable features which can significantly reduce the
load on the system microcontroller allowing for a simpler and cheaper microcontroller.
The digital modem includes the TX Modulator which converts the TX Data bits into the corresponding stream of digital
modulation values to be summed with the fractional input to the sigma-delta modulator. This modulation approach results
in highly accurate resolution of the frequency deviation. A Gaussian filter is implemented to support GFSK, considerably
reducing the energy in the adjacent channels. The bandwidth-time product (BT) is 0.5 for all programmed data rates.
5.6. Synthesizer
An integrated Sigma Delta (ΣΔ) Fractional-N PLL synthesizer capable of operating from 240–930 MHz is provided on-chip.
Using a ΣΔ synthesizer has many advantages; it provides large amounts of flexibility in choosing data rate, deviation,
channel frequency, and channel spacing. The transmit modulation is applied directly to the loop in the digital domain
through the fractional divider which results in very precise accuracy and control over the transmit deviation.
The PLL and Δ-Σ modulator scheme is designed to support any desired frequency and channel spacing in the range from
240–930 MHz with a frequency resolution of 156.25 Hz (Low band) or 312.5 Hz (High band). The transmit data rate can be
programmed between 1–128 kbps, and the frequency deviation can be programmed between ±1–160 kHz. These
parameters may be adjusted via registers as shown in "3.6. Frequency Control".
34
Tel: +86-755-82973805
Fax: +86-755-82973550
E-mail: sales@hoperf.com
http://www.hoperf.com
HOPERF [ HOPERF ]
