V
DD
V
DD
V
DD
R
EXT
SWC
6k8
C
EXT
EXTERNAL
COMPONENTS
GND
OUTPUT
GS9000D
Fig. 5 Pin 15 SWC
Fig. 6 Pins 3, 16, 17, 19 - 25, 27, 28
SWF, HSYNC, SSI, SSD, PCLK, PD0-9
t
CLKL
=
t
CLKH
1/
T
2
1/
2
T
SERIAL
CLOCK
(SCI)
50%
PARALLEL
DATA
(PDn)
SERIAL
DATA
(SDI)
PARALLEL
CLOCK
(PCLK)
50%
t
SU
t
HOLD
Fig. 7 Waveforms
t
D
TEST SET-UP & APPLICATION INFORMATION
Figure 8 shows the test set-up for the GS9000D operating
from a V
DD
supply of +5 volts. The differential pseudo ECL
inputs for DATA and CLOCK (pins 5,6,7 and 8) must be
biased between +3.0 and +4.05 volts.
In the application
circuit shown in Figure 11, these inputs can be directly
driven from the outputs of the GS7025 Reclocking Receiver
with their resistor values set as shown.
In other cases, such as true ECL level driver outputs, two
biasing resistors are needed on the DATA and CLOCK
inputs and the signals must be AC coupled.
It is critical that the decoupling capacitors connected to
pins 12,13 and 18 are chip types and are located as close
as possible to the device pins.
The critical high speed inputs, such as Serial Data
(pins 5 and 6) and Serial Clock (pins 7 and 8), are located
along one side of the device package to maintain very short
interconnections when interfacing with the GS7025
Receiver.
If the automatic standard select function is not used, the
Standard Select bits (pins 9 and 10) do not need to be
connected, however the control input (pin 11) should be
grounded.
6 of 9
GENNUM CORPORATION
18784 - 3