GL9701 PCI ExpressTM to PCI Bridge
INTD_N
PME_N
I
Power management event from secondary interface
WAKE_N
OD
Used to implement wakeup mechanism.
3.4.3 EEPROM Signals
Name
PROMCS
Type
Description
Enable EEPROM interface
O
O
I
PROMDO
PROMDI
PROMSK
Serial data output for EEPROM
Serial data input from EEPROM
Serial clock output for EEPROM
O
3.4.4 Miscellaneous Signals
Name
Type
Description
GPIO[6:0]
TS
The output signals are determined by OPMODE[1:0],
PCICLKx_MASK(x=0~5) in design option.
▪For GPIO[2:0]:
Available only in normal mode. (OPMODE[1:0]=2’b00)
▪ If PCICLKx_MASK (x=0~2) are not masked (=1’b0), then
these three bits are used as PCI clock outputs. It’s recommended
that GPIO[0] be routed to PCICLKI input.
▪ If PCICLKx_MASK (x=0~2) are masked (=1’b1) then these
three bits are used as output of GPIO signal from design option.
▪For GPIO[5:3]:
▪ If in normal function mode (OPMODE[1:0]=2’b00), then these
three bits are used as PCI clock outputs when
PCICLKx_MASK(x=5~3) are not masked (=1’b0). These three
bits are used as GPIO output from design option if
PCICLKx_MASK(x=5~3) are masked (=1’b1).
▪ If in test mode (OPMODE[1:0]=2’b01), then these three bits are
used as internal signal output.
▪For GPIO[6]:
▪ If in normal function mode (OPMODE[1:0]=2’b00), the bit is
used as GPIO pins. Users can specify the output value and
©2000-2006 Genesys Logic Inc. - All rights reserved.
Page 18