MBM29LV008TA-70/-90/-12/MBM29LV008BA-70/-90/-12
Autoselect Command
Flash memories are intended for use in applications where the local CPU alters memory contents. As such,
manufacture and device codes must be accessible while the devices reside in the target system. PROM
programmers typically access the signature codes by raising A9 to a high voltage. However, multiplexing high
voltage onto the address lines is not generally desired system design practice.
The device contains an Autoselect command operation to supplement traditional PROM programming
methodology. The operation is initiated by writing the Autoselect command sequence into the command register.
Following the command write, a read cycle from address XX00H retrieves the manufacture code of 04H. A read
cycle from address XX01H returns the device code (MBM29LV008TA = 3EH and MBM29LV008BA = 37H). (See
Tables 3.1 and 3.2.) All manufacturer and device codes will exhibit odd parity with DQ7 defined as the parity bit.
Sector state (protection or unprotection) will be informed by address XX02H.
Scanning the sector addresses (A19, A18, A17, A16, A15, A14, and A13) while (A10, A6, A1, A0) = (0, 0, 1, 0) will produce
a logical “1” at device output DQ0 for a protected sector. The programming verification should be perform margin
mode on the protected sector. (See Tables 2 and 3.)
To terminate the operation, it is necessary to write the Read/Reset command sequence into the register, and
also to write the Autoselect command during the operation, execute it after writing Read/Reset command
sequence.
Byte Programming
The devices are programmed on a byte-by-byte basis. Programming is a four bus cycle operation. There are
two “unlock” write cycles. These are followed by the program set-up command and data write cycles. Addresses
are latched on the falling edge of CE or WE, whichever happens later and the data is latched on the rising edge
of CE or WE, whichever happens first. The rising edge of CE or WE (whichever happens first) begins
programming.UponexecutingtheEmbeddedProgramAlgorithmcommandsequence,thesystemisnotrequired
to provide further controls or timings. The device will automatically provide adequate internally generated
program pulses and verify the programmed cell margin.
The automatic programming operation is completed when the data on DQ7 is equivalent to data written to this
bitatwhichtimethedevicesreturntothereadmodeandaddressesarenolongerlatched. (SeeTable8, Hardware
Sequence Flags.) Therefore, the devices require that a valid address to the devices be supplied by the system
at this particular instance of time. Hence, Data Polling must be performed at the memory location which is being
programmed.
Any commands written to the chip during this period will be ignored. If hardware reset occurs during the
programming operation, it is impossible to guarantee the data are being written.
Programming is allowed in any sequence and across sector boundaries. Beware that a data “0” cannot be
programmed back to a “1”. Attempting to do so may either hang up the device or result in an apparent success
according to the data polling algorithm but a read from read/reset mode will show that the data is still “0”. Only
erase operations can convert “0”s to “1”s.
Figure 17 illustrates the Embedded ProgramTM Algorithm using typical command strings and bus operations.
16
FUJITSU [ FUJITSU ]
