Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.3
GPIO [16:23] Connector CN5
Figure 5.4
GPIO[16:23] Connector CN5
VCN2 Pin No
32-PIN
-
-
-
-
23
24
(10)
25
26
(10)
-
-
-
-
48-PIN
-
46
45
48
31
32
(10)
33
34
(10)
-
-
-
-
64-PIN
27
28
29
31
32
39
40
41
-
-
-
-
Signal name
GPIO16
GPIO17
GPIO18
GPIO19
GPIO20
GPIO21
GPIO22
GPIO23
GND
3.3V
(11)
GND
5V
(12)
(9)
(9)
(9)
(9)
(9)
(9)
(9)
(9)
Connector
pin
1
2
3
4
5
6
7
8
9
10
11
12
IO
type
IO
IO
IO
IO
IO
IO
IO
IO
-
-
-
-
Description
GPIO port, data bit 16
GPIO port, data bit 17
GPIO port, data bit 18
GPIO port, data bit19
GPIO port, data bit 20
GPIO port, data bit 21
GPIO port, data bit 22
GPIO port, data bit 23
Ground pin
3.3V power rail.
Ground pin
5V power rail.
Notes:
(9)
All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
(10) The following pins are only accessible on VNC2 when the onboard multiplexer select input is high. See
section 6.4 for details.
(11) This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
(12) This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
GPIO port connector CN5
Table 5.3
Copyright © 2010 Future Technology Devices International Limited
16