Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2 GPIO BUS Connectors
The V2-EVAL board features a set of 6 connectors providing access to GPIO capable pins on the VNC2
device. The GPIO pins are distributed across 6 connectors. The configuration of each connector is
outlined in subsequent sections. Further each connector has a 5V and 3.3V power and GND pins.
5.2.1
GPIO [0:7] Connector CN3
Figure 5.2
GPIO[0:7] Connector CN3
VCN2 Pin No
32-PIN
11
12
14
15
-
-
-
-
-
-
-
-
48-PIN
11
12
13
14
-
-
-
-
-
-
-
-
64-PIN
11
12
13
14
15
16
17
18
-
-
-
-
Signal
name
GPIO0
GPIO1
GPIO2
GPIO3
GPIO4
GPIO5
GPIO6
GPIO7
GND
3.3V
(4)
GND
5V
(5)
(3)
(3)
(3)
(3)
(3)
(3)
(3)
(3)
Connector
pin
1
2
3
4
5
6
7
8
9
10
11
12
IO
type
IO
IO
IO
IO
IO
IO
IO
IO
-
-
-
-
Description
GPIO data bit 0
GPIO data bit 1
GPIO data bit 2
GPIO port, data bit 3
GPIO port, data bit 4
GPIO port, data bit 5
GPIO port, data bit 6
GPIO port, data bit 7
Ground pin
3.3V power rail.
Ground pin
5V power rail.
Notes:
(3)
(4)
(5)
All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
GPIO[0:7] port connector CN3
Table 5.1
Copyright © 2010 Future Technology Devices International Limited
14
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
