Document No.: FT_000061
FT2232H DUAL HIGH SPEED USB TO MULTIPURPOSE UART/FIFO IC
Datasheet Version 2.09
Clearance No.: FTDI#77
4.6 MPSSE Interface Mode Description.
MPSSE Mode is designed to allow the FT2232H to interface efficiently with synchronous serial protocols
such as JTAG, I2C and SPI Bus. It can also be used to program SRAM based FPGA‟s over USB. The
MPSSE interface is designed to be flexible so that it can be configured to allow any synchronous serial
protocol (industry standard or proprietary) to be implemented using the FT2232H. MPSSE is available on
channel A and channel B.
MPSSE is fully configurable, and is programmed by sending commands down the data stream. These can
be sent individually or more efficiently in packets. MPSSE is capable of a maximum sustained data rate of
30 Mbits/s.
When a channel is configured in MPSSE mode, the IO timing and signals used are shown in Figure 4.7
and Table 4.3 These show timings for CLKOUT=30MHz. CLKOUT can be divided internally to be provide a
slower clock.
Figure 4.7 MPSSE Signal Waveforms
NAME
t1
t2
t3
t4
t5
t6
MIN
15
15
1
0
11
NOM
33.33
16.67
16.67
MAX
7.15
Units
ns
ns
ns
ns
ns
COMMENT
CLKOUT period
CLKOUT high period
CLKOUT low period
CLKOUT to TDI/DO delay
TDO/DI hold time
TDO/DI setup time
Table 4.3 MPSSE Signal Timings
MPSSE mode is enabled using Set Bit Bang Mode driver command. A hex value of 2 will enable it, and a
hex value of 0 will reset the device. See application note
AN2232L-02, “Bit Mode Functions for the
FT2232D”
for more details and examples.
The MPSSE command set is fully described in application note
AN_108 – “Command Processor For
MPSSE and MCU Host Bus Emulation Modes”.
The following additional application notes are available for configuring the MPSSE :
AN_109 – “Programming Guide for High Speed FTCI2C DLL”
AN_110 – “Programming Guide for High Speed FTCJTAG DLL”
AN_111 – “Programming Guide for High Speed FTCSPI DLL”
Copyright © 2010 Future Technology Devices International Limited
28
FTDI [ FUTURE TECHNOLOGY DEVICES INTERNATIONAL LTD. ]
