欢迎访问ic37.com |
会员登录 免费注册
发布采购

MC68HC908AP64CFB 参数 Datasheet PDF下载

MC68HC908AP64CFB图片预览
型号: MC68HC908AP64CFB
PDF下载: 下载PDF文件 查看货源
内容描述: [MC68HC908AP64CFB]
分类和应用: 外围集成电路时钟
文件页数/大小: 325 页 / 1651 K
品牌: FREESCALE [ Freescale ]
 浏览型号MC68HC908AP64CFB的Datasheet PDF文件第169页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第170页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第171页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第172页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第174页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第175页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第176页浏览型号MC68HC908AP64CFB的Datasheet PDF文件第177页  
Serial Communications Interface Module (SCI)  
TE — Transmitter Enable Bit  
Setting this read/write bit begins the transmission by sending a preamble of 10 or 11 logic 1s from the  
transmit shift register to the TxD pin. If software clears the TE bit, the transmitter completes any  
transmission in progress before the TxD returns to the idle condition (logic 1). Clearing and then setting  
TE during a transmission queues an idle character to be sent after the character currently being  
transmitted. Reset clears the TE bit.  
1 = Transmitter enabled  
0 = Transmitter disabled  
NOTE  
Writing to the TE bit is not allowed when the enable SCI bit (ENSCI) is clear.  
ENSCI is in SCI control register 1.  
RE — Receiver Enable Bit  
Setting this read/write bit enables the receiver. Clearing the RE bit disables the receiver but does not  
affect receiver interrupt flag bits. Reset clears the RE bit.  
1 = Receiver enabled  
0 = Receiver disabled  
NOTE  
Writing to the RE bit is not allowed when the enable SCI bit (ENSCI) is  
clear. ENSCI is in SCI control register 1.  
RWU — Receiver Wakeup Bit  
This read/write bit puts the receiver in a standby state during which receiver interrupts are disabled.  
The WAKE bit in SCC1 determines whether an idle input or an address mark brings the receiver out  
of the standby state and clears the RWU bit. Reset clears the RWU bit.  
1 = Standby state  
0 = Normal operation  
SBK — Send Break Bit  
Setting and then clearing this read/write bit transmits a break character followed by a logic 1. The logic  
1 after the break character guarantees recognition of a valid start bit. If SBK remains set, the  
transmitter continuously transmits break characters with no logic 1s between them. Reset clears the  
SBK bit.  
1 = Transmit break characters  
0 = No break characters being transmitted  
NOTE  
Do not toggle the SBK bit immediately after setting the SCTE bit. Toggling  
SBK before the preamble begins causes the SCI to send a break character  
instead of a preamble.  
MC68HC908AP Family Data Sheet, Rev. 4  
172  
Freescale Semiconductor  
 复制成功!