Data/Program RAM. Program Flash memory can be independently bulk erased or erased in pages.
Program Flash page erase size is 512 Bytes (256 Words).
A full set of programmable peripherals — PWM, ADCs, QSCI, QSPI, I2C, PITs, Quad Timers, DACs,
and analog comparators — supports various applications. Each peripheral can be independently shut down
to save power. Any pin in these peripherals can also be used as General Purpose Input/Outputs (GPIOs).
1.3 Award-Winning Development Environment
Processor Expert
TM
(PE) provides a Rapid Application Design (RAD) tool that combines easy-to-use
component-based software application creation with an expert knowledge system.
The CodeWarrior Integrated Development Environment is a sophisticated tool for code navigation,
compiling, and debugging. A complete set of evaluation modules (EVMs), demonstration board kit and
development system cards will support concurrent engineering. Together, PE, CodeWarrior and EVMs
create a complete, scalable tools solution for easy, fast, and efficient development.
1.4 Architecture Block Diagram
The 56F8025’s architecture is shown in
Figures 1-1, 1-2, 1-3, 1-4, 1-5, 1-6,
and
illustrates
how the 56800E system buses communicate with internal memories and the IPBus Bridge and the internal
connections between each unit of the 56800E core.
shows the peripherals and control blocks
connected to the IPBus Bridge.
Figures 1-3, 1-4, 1-5, 1-6,
and
detail how the device’s I/O pins are
muxed. The figures do not show the on-board regulator and power and ground signals. Please see
for information about which signals are multiplexed with those of other
peripherals.
1.4.1
PWM, TMR and ADC Connections
shows the over- and under-voltage connections from the ADC to the PWM and the connections
to the PWM from the TMR and GPIO. These signals can control the PWM outputs in a similar manner to
the over- and under-voltage control signals. See the
56F802x and 56F803x Peripheral Reference
Manual
for additional information.
The PWM_reload_sync output can be connected to the Timer’s Channel 3 input and the Timer’s Channels
2 and 3 outputs are connected to the ADC sync inputs. Timer Channel 3 output is connected to SYNC0
and Timer Channel 2 is connected to SYNC1. These are controlled by bits in the SIM Control Register;
see
56F8025 Data Sheet, Rev. 3
8
Freescale Semiconductor
Preliminary
FREESCALE [ FREESCALE SEMICONDUCTOR, INC ]
